Using Remote Jack / MD Output / D&N Input

Operating Your Camera

IMAGE ADJ: This includes the factors related to the image quality or special function.

-H-REV : Set ‘ON’, then each side of image(left and right) is exchanged on vertical axis.

-V-REV : Set ‘ON’, then image changes upside down.

-TONE : As you increase the value using left or right button the whole level would be brighter.

-SHARPNESS : As the value goes high, edge of image become strong and obvious. But if increasing the value too much, some noise may appears on image and image may looks unnatural.

-COLOR : As you increase or decrease the value, image chroma level increases or decreases but the burst level doesn’t.

1. RS-232C Communication Setting.
• Mode : Serial		• Data Bit : 8	• Bit/sec : 9600bps	• Stop Bit : 2
• Port : Com1		• Parity : None	• Flow Control : XON/XOFF
2. Setup menu Command.

	Setup menu		Command	Byte
	Set		153	1
	Up		65	1
	Down		66	1
	Right		67	1
	Left		68	1

3. MD(Motion Detection) output Signal Level(less than 10mA)

PRESET: To reset your camera to factory default condition

RETURN: To move Top-menu EXIT: To finish setting menu

Notes

• the reflected letters on mirror will be seen when activating H-REV or V-REV.

There is no motion

+4.0V~+5.0V

There is motion

5±0.5sec

Using Remote Jack / MD Output / D&N Input

If you connect a remote plug to the REMOTE jack on the rear of the camera as shown below, you can access the menu setup mode from a remote place.

COLOR CCD CAMERA 40 User’s Manual

4.D&N input Control Signal

If you want to use EXT mode, consist proper system that satisfy below condition

•For DAY mode, D&N terminal should be open from GND terminal.

•For B/W mode, D&N terminal should be short to GND terminal.

Notes

• You must turn the camera power off when you connect or remove the remote plug.

COLOR CCD CAMERA 41 User’s Manual