Sealife DC250 manual Test camera and housing

12.Do not allow any water droplets to get inside housing. This will cause the inside of the housing to fog.

13.Close housing lid tightly. Make sure there are no obstructions that prevent the housing from closing. Make sure lid is tightly pressed into housing, ( see picture).

14.Close housing latch. Make sure the lid is pressed flat and evenly against the housing body. The housing may leak if

Close housing lid tightly, then close	the lid is not flat against the housing
latch.	when closed.

E

Test camera and housing

1.Press the external power button on the top of the housing to turn camera power on.

2.Press the shutter button on the outside of the housing to take a test picture.

3.The power or shutter button should have a smooth action and return to its original resting position after pressing. It is normal to feel some resistance when pressing the power and shutter button.

4.Press and hold power button to turn camera power off. It is recommended to leave camera power off until you’re ready to use camera to preserve battery power.

5.After 3 minutes the LCD and monitor will turn off, and the camera will in power save mode. To re-activate power, push the SHUTTER BUTTON.

6.After 15 minutes the camera power will shut down. To operate the camera, push the POWER BUTTON to turn on the camera.

63