FIBERworks® Lens Assembly Installation Instructions
STOP!
Read and follow all instructions!
We recommend that all FIBERworks lens assemblies be installed by trained and certified FIBERworks
dealers only.
If you have any questions please call our service hot line, Monday through Friday,
7:30 a.m. to 4:30 p.m., at (800)
Installing the Lens Housing
∙FIBERworks lens housings are installed the same way water return fittings are installed.
CAUTION
DO NOT use excessive glue. Excess glue can overflow onto the
∙Use only Pentair Pool Products’ FIBERworks lens housings. Other fittings will not adequately seal conduit from pool water.
∙Cut the conduit back as shown in the adjacent figure. Dimension “a” should be one inch (1”) for a FIBERworks Standard Gunite housing, and one and a half inches (1½”) for a FIBERworks Invisible Gunite housing.
4 in.
a
Plaster surface
Gunite
Gunite cutback - 1 ¼”
To Photon
Generator
Conduit
Lens Selection for preOptifusedTM and Bulk Cable Assemblies
∙Every lens assembly and preOptifused cable assembly now comes with a standard and wide angle lens. See lens assembly drawing to identify different lens types. Use the table below to select the appropriate lens for your application.
Lens |
|
| Lens Position |
|
| |
Type | Shallow End | Deep End |
| All Side Wall | Shadow Filler | Spa |
Standard | X |
|
|
|
|
|
Wide Angle |
| X |
| X | X | X |
∙Positioning on the pool/spa wall is the same for both lens types. Follow the recommendations in the Photon Generator Installation and Service Manual for proper lens positioning.
∙DO NOT use any gel on the wide angle lens. This will inhibit the light dispersion capabilities of the lens. PreOptifused cable assemblies come with the standard lens and Optifusion gel. Wipe excess gel off of cable face with a clean cloth before installing the wide angle lens.
∙A new lens tightening tool with longer pins (p/n 21006500) will be required to install the wide angle lens.