Pentair Wide Angle Lens Installing the Cable and Lens Subassembly, FIBERworks lens housing

Page 2

Installing the Cable and Lens Subassembly

(for preOptiFused and bulk cable applications)

Feed the AmerGlow cable through the conduit leaving one foot of extra cable at each end.

If using bulk cable, assemble the lens subassembly as shown in the figure below.

Terminate the cable using the OptiFusion process as described in the full instructions packed with the Photon Generator or OptiFusion Termination Kit. Any other process may dramatically reduce light output.

Seal nut o-ring

Compression nut

Grommet

 

1/16”

 

1”

FIBERworks lens housing

Spacer with o-ring - use

(Invisible Gunite shown)

with Invisible Gunite and

 

Vinyl Liner lens housings

Wide Angle

Standard

Lens

 

Lens

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Seal nut

 

Lens retaining

Lens o-ring

nut

CAUTION

DO NOT use Optifusion gel on the wide angle lens. The gel will inhibit the light dispersion

capabilities of the lens and the lens will not perform as intended.

Make sure the lens o-ring and spacer o-ring (if applicable) are in position and the o-ring sealing surface on the inner flange of the lens housing is clean.

Continue feeding the cable until the lens assembly is about ½” away from the seated position.

Place the lens retaining nut onto the lens and PUSH the lens into place.

Hand tighten the lens using the lens tightening tool until the o-ring is seated.

For Standard Gunite and Fiberglass lens housings (which do not use the spacer and spacer o- ring), hand tighten the lens retaining nut ¼ turn past the seated o-ring position.

For Invisible Gunite and Vinyl Liner housings (which use the spacer and spacer o-ring) hand tighten the lens retaining nut ½ turn past the seated o-ring position.

CAUTION

DO NOT over tighten lens retaining nut. Damage to lens assembly may result in

leakage of pool water into conduit.

Save These Instructions

4/04/02

Instruction P/N 99293000

Rev B

Pentair Pool Products

1620 Hawkins Ave., Sanford, NC 27330 ~ (919) 774-4151

10951 West Los Angeles Ave., Moorpark, CA 93021 ~ (805) 523-2400

Image 2
Contents Stop FIBERworks Lens Assembly Installation InstructionsInstalling the Lens Housing Read and follow all instructionsInvisible Gunite shown Installing the Cable and Lens SubassemblyFIBERworks lens housing