Lens Replacement and Installation Procedure, Fig-1

LENS REPLACEMENT AND INSTALLATION PROCEDURE

Perform the steps

for lens replacement and installation.

UPPER LENS COVER		C

REMOVE THE LENS COVER. (See figure-1)

1. Remove screws A (2 screws).

2. Pull down the lower lens cover while pushing the part D, then remove it.

3. Remove screws B (2 screws).

4. Remove screws C (2 screws) and remove upper lens cover.

2		D	Fig-1
● IN CASE OF MODEL WITHOUT LENS	A		LOWER LENS COVER

REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)

Remove 2 screws and pull down the plate.

(At the step 4 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used.)

Set the light-block sheet, so that the large rounder side is set over the lens.

SCREWS

COVER PLATE

LENS MOTOR

(D)(D)

REMOVE THE LENS. (See figure-3.)

1.Remove the connector “K16B” of the circuit board.

2.Loosen the A, B wire holder and remove the lens motor lead.

3.Remove screws D (4 screws) which fastens the lens and remove the lens.

(D)(D)

LENS

MOTOR LEAD

CONNECTOR “ K16B”