Sanyo LNS-T01Z, LNS-W01Z installation manual Fig-4, Fig-5, Fig-6

3INSTALL THE LENS. (See figure-4)

1.Remove protective caps(front and back) on the lens.

2.Mount the lens on mounting bracket of the main cabinet with 4 screws.

Use the screws included with the lens. Use the driver included with the lens to fasten the screws.

(After using, save it for latter use.)

ATTACHED DRIVER

4INSTALL THE LIGHT-BLOCK SHEET. (See figure-5)

Install the light-block sheet around the lens as shown in the illustration. Use the sheet included with the lens.

When this projector permanently install in the structure, slide the picture, obtain cor- rect focus, then lock the lens by Focus Lens Lock screw at this step.

Adjust focus by rotating the lens.

LENS MOUNTING BRACKET

Fig-4

FOCUS LENS LOCK SCREW

LIGHT-BLOCK SHEET

Fig-5

5

MOUNT THE LENS COVER. (See figure-6)

When in install the both upper and lower lens covers, install the light-block sheet so that it should be placed in the guide slot. (place of the cover plate had been placed. See figure-2.) If the installation of light-block sheet is incorrect, it will be the cause of leakage of light or the dust entering at the main cabinet.

1.Insert the upper part lens cover and fix them with screws A (4 screws).

2.Insert the lower part lens cover and fix them with screws B. (2 screws).

UPPER LENS COVER

A

A

B

LOWER LENS COVER

Fig-6