Statement of FCC Compliance

*16 Vignetting will occur at focal lengths between 28mm-35mm and focus distance is less than 1m at 35mm.

*17 Vignetting will occur at focal lengths between 80mm-135mm.

*18 Vignetting will occur at focal lengths between 80mm-90mm.

*19 Even the Lens warning is blinking with Z-1, Z-5 and Z10, built-in flash can be used if the focus distance is more than 0.7m which is within distance of Minimum Auto flash distance.

*20 Vignetting will occur at focus distance less than 1m.

Even the Lens waning is blinking with Z-1, Z-5 and Z10, built-in flash can be used freely at focus distance more than 1m.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harm- ful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not approved by the patry responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These lim- its are designed to proviede reasonable protec- tion against harmful interference in a residential

installation, This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures :

•Reorient or relocate the receiving antenna.

•Increase the separation between the equip- ment and receiver.