KiWi ClickDiscs
How to install and remove ClickDisc indexing discs
Disassembly
1)The Rotator Base is held together with a recessed set screw which is located at the zero degree position on the barrel. Use the set screw wrench lo- cated in the blue accessory pouch and loosen the set screw (do not remove) by turning several revolutions
2)With the set screw loosened, remove the axle by pulling up on the knob which contains the bubble level.
3)The axle has a thin plastic washer.This washer should always go between the knob of the axle and the horizontal plate. Leave the plastic washer on the axle.
4)You can remove the ClickDisc from its cavity in the top of the indexing barrel by pulling up on the tab of the ClickDisc.
Rotator Base Assembly | ClickDisc Accessory Pouch with 6 |
| ClickDiscs and Set Screw Wrench |
Set Screw Wrench in Barrel | Barrel w/ClickDisc |
| Installed |
3