Miller Camera Support 25 manual Pan / Tilt Drag Control, Pan/Tilt Lock Control, Illumination

Page 9

Operating Instructions

4. Pan / Tilt Drag Control.

The Arrow 25 Fluid Head offers 5 selectable positions of fluid drag + zero setting in the Pan and Tilt. The settings are equally stepped from light drag in position 1 up to heavy drag in position 5, the drag plates are completely disengaged in position zero.

Do not Pan or Tilt the Fluid Head whilst adjusting PAN or TILT DRAG CONTROL or whilst the PAN & TIL DRAG CONTROL is between settings.

The drag setting can be changed at any tilt or pan angle.

5. Pan/Tilt Lock Control.

The Arrow 25 Fluid Head offers high capacity calliper disc brake system to hold the Fluid Head in a fixed pan and/or tilt position. Camera position will not change when applying or releasing the Pan/Tilt locks.

Do not pan or tilt the Fluid Head whilst the PAN or the TILT LOCK is partially applied.

6. Illumination.

The Arrow 25 Fluid Head offers illumination of the PAN & TILT DRAG CONTROL settings, BUBBLE LEVEL and PAN & TILT INDICATOR when the low ambient light conditions exist. Illumination can be achieved by pressing the ILLUMINATION BUTTON once. The light will switch off after 10 seconds.

Tilt Drag Setting

Illumination Button

Counter Balance Selector

Pan Drag Setting

Fig. 7

 

Pan Indicator

 

 

 

Tilt Drag Knob

Tilt Indicator

Bubble Level

Pan Drag Knob

8

Image 9
Contents Arrow Features and Controls Features and Controls Attaching/removing the camera Introduction Safety InstructionsTechnical Data Fluid Head Set-up Operating InstructionsCamera Set-up Counterbalance Performance Counterbalance ControlPan / Tilt Drag Control Pan/Tilt Lock ControlIllumination Battery Replacement MaintenanceSpare Parts and Accessories Service, Sales and SupportStorage Miller Camera Support Equipment