Apollo 645-062 owner manual Introduction, Unpacking the Apollo Monoblocks, Tools required none

Page 3

INTRODUCTION

Congratulations on your purchase decision! We at Rogue Audio truly believe that our amplifiers provide the “smartest” value in high-end aud io. If you have never owned a vacuum tube amplifier you will be thrilled by the silky-smooth sound and incredible detail that only a tube amplifier can provide. And with the Apollo monoblock amplifiers, you can be sure that you are getting the very best in tube amplification. We at Rogue Audio are extremely proud of our products and want you to enjoy them to their fullest potential. So please, take the time to read through this short manual so that you can be confident that you have set up your amplifier properly.

UNPACKING THE APOLLO MONOBLOCKS

Tools required: none

WARNING - This amplifier uses voltages that could cause injury or death. Never open the amplifier while it is plugged in, and always wait at least one hour after turning the unit off to unplug and open the unit. Lethal voltages can remain in the electronics after the unit is unplugged.

The Apollo amplifier has been painstakingly inspected for cosmetic flaws during and after assembly. In order not to damage the cosmetic appearance of your amplifier it is important that you follow the unpacking instructions carefully.

1.Carefully lift the outer box up and over the amplifiers.

2.Remove the foam pads from the top of the amplifiers.

3.The Apollo has two built in handles on either end of the amplifier. Remove any rings or jewelry that can scratch the aluminum finish. CAUTION – The Apollo amplifier weighs 100 pounds. Carefully lift the amplifier and move it to its operational location. Note – this is not a one person job!

4.Save the packing materials. The packing materials and box have been carefully designed to protect your valuable equipment during shipping so you don’t want to throw them away.

5.Align Tubes - Using a glove or a clean dry cloth, straighten any tubes that may have tilted during shipment. Ensure that all of the tubes are fully seated in their ceramic sockets.

3

Image 3
Contents Apollo Table of Contents Introduction Unpacking the Apollo MonoblocksTools required none Connecting the Apollos Into Your System Connecting Apollo to the LoudspeakersConnecting Apollo to the preamplifier Connecting Apollo to the power outlet Triode/Ultralinear switchOperation of the Apollo Amplifiers Setting the Tube Bias Bias switches and Potentiometers Troubleshooting Owner and Warranty Registration Form SpecificationsFuse Values Limited Warranty