POLAROID XS100 USER GUIDE
CHARGING THE BATTERY
1.Connect the USB cable’s mini USB plug into the camera’s mini USB port.
2.Connect the cable’s USB plug into a USB port of any computer. Verify that the computer is on.
3.The Red LED remains on while the battery is charging.
4.The Red LED will turn off when the battery is fully charged.
5.Charge the battery before using the camera for the very first time.
6.It takes about 3 hours to initially charge the camera. Subsequent charges will take 3 hours or less.
Additional Information
When the battery power is low, the camera will vibrate three times to indicate a low battery. The camera will vibrate two seconds to indicate it's out of power. If the camera is recording, it will automatically save the file and then shut down.
DO NOT attempt to remove the internal battery. Doing so will void the warranty coverage and can possibly damage the camera.
Insert Micro SD Card
The XS100 supports MicroSD cards up to 32GB (Class 6 or greater cards are recommended). At the rate of 4GB per
Check that the camera power is turned OFF. Insert a MicroSD card (with the printed side up) into the MicroSD Card Slot with enough finger pressure to keep the edge of the card flush with the card slot opening.
To remove the
Never insert a MicroSD card with the printed side down. Forcing the card inward in that position will likely damage the card and/or camera.
4