PREPARATION OF THE PORTS
1. Select the correct port:
Depending on whether you’ve decided to shoot macro or wide angle photography, you will be installing either a flat Macro Port (product
#18426 or 18428), or a Dome Port (Product # 18405*, 18407 or 18409). See lens chart for the suggest port and accessories. * an extension is needed at all time with this port
Macro Port Extension Rings: the Macro Ports will accept short standard and macro lenses without extension. If you intend to use a longer lens you will require an additional extension ring. These extension rings fit between the Macro Port and the housing to provide the extra space necessary for the longer lens.
Dome Port Extension Rings: When using a wide angle or zoom lens, the Dome Port may require the uses of an extension ring to closely match the optical center of both the dome and the lens.
In order to reduce glare, maximize contrast and offer physical protection to the dome, the use of a dome shade is highly recommended. See lens chart for the suggested dome shade.
A comprehensive list of the lenses supported and their required extensions and/or accessories is supplied at the end of this manual. For the latest uptdated version of this lens chart, you can refer to the Lens Chart on www.aquatica.ca
2. Clean the port:
Dirt, grease or fingerprints on the port especially on the inside, can adversely affect the quality of the image. Acrylic ports should be cleaned with plastic cleaner and the glass ports should be cleaned with lens cleaner. For more details be sure to read the section titled “Care and Maintenance: of the Ports.”
3. Lubricate the port O-ring seal:
Before using the port, remove the
PREPARATION OF THE LENS
Depending on the lens used, there are a number of gear options possible. Using the right gear and correctly mounting them on the lens is very important for a smooth operation. Follow the installation directions included with each gears carefully. Since the aperture control is achieved through the Main or Quick Command Dial, the use of lenses of the EF types is mandatory.
A comprehensive list of the lenses supported and their required gears is supplied at the end of this manual. For the latest uptdated version of this lens chart, you can refer to the Lens Chart on www.aquatica.ca
Notes: If the camera is set in manual focus a focus gear must be mounted on the lens. If you are using a zoom lens with a zoom ring the camera must be on auto focus, also note that if using a dome port you may need to install a closeup diopter on the lens to correct the minimum focusing distance of the lens so that it will be able to focus on the virtual image created by the dome. See lens chart to confirm if a
Gear installation:
Mount the focus gear over the focus ring of the lens.
(a)For
(b)For gears with mounting screws:Tighten the three set screws evenly. Tighten each screw approximately ½ a turn working around the gear until all the three (3) screws are tightened, and the gear is concentric with the lens body.
CAUTION: Do not
Rotate the focus ring several times to make sure it moves smoothly and the gear does not slip before closing the housing
WARNING: If the lens is a not of the USM type, never attempt to manually operate the focus with the camera in autofocus mode and with a mounted focus gear engaged. This might cause serious damage to your camera or to the lens. With standard EF lenses you must select the method of focusing prior to installing the lens in the housing.
Zoom lenses: When using a zoom lens, the gear should be mounted on the zoom lens control. The housing focus control then
becomes the zoom control. Focusing of lens is achieved by using the camera’s autofocus system. | page 6 |
|