CAMERA PREPARATION AND INSTALLATION
1.Important Note: prior to installing the camera in the housing, remove the camera strap, “D” Clips and/or any object that might obstruct installation or get in the way of that attach the strap should be removed or tucked away
3. Make sure the lens lock lever is in the proper UP position
4. Remove the saddle from the housing and carefully place the camera on it and ensure the camera is properly installed and aligned as follows:
a) The camera is properly aligned and secured against rotation or movement.
b) Align the Tripod Socket of the camera with the mounting screw. Tighten the mounting screw securely while ensuring that the camera position is not altered. set arresting block as per drawing at right.
c) Slide the quick release tray back and lock into place as per drawing at right.
CLOSING OF THE HOUSING
Once the camera is secure on the saddle inside the front half of the housing, simply:
1. Slide the housing’s hot shoe connector onto the hot shoe base of the camera, as seen in drawing at right.
Before closing the housing always ensure that:
1. The main
2.The sealing surface on the rear half of the housing is clean and free from any scratches or physical damage.
3.All cords or wires are tucked in so that they do not interfere with the closing of the housing.
To close the housing simply:
i.Join the front and rear halves of the housing using the two dowel pins at the bottom of the housing as a guide.
ii.Hold the housing with both hands and look around the sealing surface to ensure that the
iii.First close the two sides latches simultaneously, then the top one. reverse the process to open housing
CAUTION: if you feel any resistance as you attempt to close the latches, do not force the closure. Check for an obstruction and try again.
iv.Verify that the safety locking mechanisms of the latches are properly engaged to avoid any accidental opening.
page 7