Flash will not ﬁre

Flash set to OFF -Set the ﬂash to Auto or On. Flash has not been fully charged The ﬂash takes a few seconds to charge up while the Operation

LED is blinking. Flash light is fully charged when the Operation LED turns off.

Battery level is low - When the battery indicator does not show a fully charged battery, the

voltage is too low for the ﬂash to work. Please change batteries.

Image is blurred / out of focus

Subject is out of focal range. Ensure that there is at least 1.5m ( 5ft ) between the camera lens and subject. Camera moved during the shot- Hold the camera steady while taking the picture. When ﬂash is on, hold the camera steady until ﬂash has ﬁred twice( The ﬁrst ﬂash is to reduce

red-eye and to detect the brightness of the target.)

Computer does not recognize camera for Windows 98SE, The camera driver has to be installed before picture download. In picture preview mode, ensure that USB mode is set to MSDC before connecting the camera to the computer. For Windows 2000/ ME /XP, the camera is recognized as a plug -&-playable, removable ﬂash disk without driver installation under MSDC mode. It is recommended that you

disconnect your digital camera from your computer after use.