HP SSA Error Messages and Troubleshooting Guide

Warning	Warning message	Comment or clarification
code
4012	The command is not availbale when	—
	MODE=RECONFIG

HP SSA scripting error messages

Error code	Error message	Comment or clarification
0	—	No error exists. The program completed
		successfully.
2053	Too many coinciding expansion, migration,	The new configuration requires more
	or extension operations	transformations than are possible at one time. For
		example, you cannot expand a logical volume and
		transform its RAID level at the same time.
2056	Controller does not support license keys	The controller does not support license key entry or
		deletion.
2059	Invalid license key	The entered license key is not a valid license key.
2064	Controller does not support SSP	The controller does not support SSP functions.
2817	Invalid Action	The requested actions are invalid, for example,
		combining -resetwith capture mode.
2818	Invalid Method	The method must be either Custom or Auto.
2819	Invalid Controller	An invalid controller value was specified.
2821	No controllers detected	No controllers were detected. This error applies to
		Input mode only.
2823	Invalid Rebuild Priority	The specified rebuild priority is not supported.
2824	Invalid Expand Priority	The specified expand priority is not supported. This
		error also occurs if the controller does not allow
		expansion, and therefore does not support expand
		priority.
2826	Array not specified	The Array command is missing from the script file.
		Some commands were found that require an Array
		to be specified.
2827	New Array ID does not match the next	The array ID in the script file does not match the
	available Array ID	array ID of the next available array. For example, if
		the configuration has an Array A and the input file
		specifies Array C (without Array B), then the script
		generates this error.
2828	New Array ID already exists	The array ID specified in the script file (in Configure
		mode) already exists in the configuration. Configure
		mode can only create new arrays.
2829	Cannot create Array	The controller will not allow a new array to be
		created, either because the controller has no
		unassigned physical drives attached or because the
		maximum number of arrays or logical drives has
		been reached already.
2830	Cannot expand Array	The Array could not be expanded, either because
		the controller does not support expansion, or the
		current configuration does not allow expansion to
		occur on the array.
2831	Cannot change Array Spare	The spare state of the array could not be changed.

Operations 106