SVAT Electronics cv501-16ch manual Remote Internet connection, Too purple, blue, etc, Any image

Page 68

Cannot view the DVR through a

Make sure the router is properly plugged in and setup

remote Internet connection

Make sure the DVR is properly plugged into the router

 

Repeat the steps in the networking guide to make sure everything was properly set up

 

If none of the above steps try contacting your ISP to make sure they are not blocking port 80

 

View the Video Networking guides on www.svat.com

Cannot view DVR on the computer

Verify the following while referring to the included networking guide

 

Make sure you are entering the proper IP address of the DVR. You will enter the Internal IP

 

 

address into the Internet Explorer address bar when the computer is connected to the same

 

 

router as the DVR

 

You will enter the external IP address into the Internet Explorer address bar when the

 

 

computer trying to access the DVR is not connected to the same router. This will require an

 

 

Internet connection

 

Port forwarding will need to have been setup according to the networking guide

 

Follow the instructions found on www.portforward.com for detailed instructions or contact

 

 

your router manufacturer for assistance with port forwarding on your particular model

 

 

of router

 

Make sure you are logged into the computer as an administrator to install the required

 

 

application and ActiveX controls

The color on the camera picture is

Try adjusting the settings in the camera setup screen to improve/change the image quality.

too purple, blue, etc

 

Unusual coloring can also be caused by the type of lighting that is used. The cameras do not

 

 

react well to halogen lighting. Try focusing the cameras away from these lights

 

Make sure that the cameras are not pointing directly at a light source such as a lamp or a

 

 

sunny window

My browser keeps freezing

Make sure you have an up to date browser and that the proper ActiveX options are selected. If

 

 

they are, you may need to re-install your browser. (Internet Explorer version 6 or higher)

Camera Troubleshooting

I cannot see at night with my IR

The night vision turns on automatically when light levels drop. Try the camera in a pitch black

night vision cameras

 

setting. The areas that it is in may have too much light and may not activate the sensor

 

 

The LEDs need to reflect off an object to view it in the dark so make sure there is an object for

 

 

it to reflect off within reasonable range

My camera is not displaying

Verify the connections are snug and tight fitting. Disconnect and reconnect each connection.

any image

 

4pin/4pin, power/power, RCA/RCA

 

• Make sure the power adapter is plugged in to an active electrical outlet

 

• If everything is connected, cup your hands around the camera lens and you should see the red

 

 

LEDs illuminate. Make sure it is dark enough to activate the light sensor

 

• If the LEDs do not illuminate, try switching the power adapter with a working camera’s power

 

adapter. This will indicate if it is the power adapter which needs to be replaced

 

If no power/video signal even with the new power adapter, connect the camera that is

 

 

in question to a working cable. (Disconnect a working camera and connect the camera in

 

 

question to that cable set) The camera should function correctly. If the camera functions

 

 

correctly the test indicates that there is a bad cable

 

• Verify the pins on the 4PIN DIN connection are not bent and are being properly inserted to the

 

 

proper connector

CV501 - 16CH

71

 

 

Image 68
Contents Table of Contents Table of Contents Login ActiveX Installation DDNS.org Ddns Account SetupTime Search Event List Search Software Buttons and ConnectionsTable of Contents IntroductionWhat is Included FeaturesFeatures Additional Accessories IR Sensor Detects IR remote controlButtons & Connections Front PanelVideo Monitor Connection BNC Monitor output Video Out Remote ControlBack Panel PTZ Connection To connect a two wire alarmButtons & Connections Power bar Things to Consider Before InstallationAdjust cameras to the desired viewing angles Connecting a USB Mouse Camera InstallationConnecting Additional Devices to the DVR Connecting Your Alarm System to the DVR Connecting a Monitor to the DVR RCA CompositeConnecting a Monitor to the DVR VGA Power supply Connecting and Powering on the DVRConnecting Your DVR to the Router Using the Mouse Getting StartedScreen Viewing POP UP Menu BARMain Menu Main menu consists of nine optionsMain Menu To call up the Main MenuVideo Adjust Main MenuCamera Camera TitlePTZ Setup DisplayDwell Time Baud Rate ProtocolPTZ Control from Live Viewing Mode Access the Main Menu Select the Motion Setup iconMotion Detection PTZ controls look like thisTo SET Motion Detection Motion DetectBuzzer SensitivityResolution PPSTo Change the Normal Record PPS Or monitorsAlarm Record PPS To Change the Alarm Record PPSAlarm Record Duration Press Enter or Click to save changes To exitAlarm Record Quality Record ModeRecord Quality To choose a recording scheduleSchedule Setup Audio RecordTo record with audio There are 3 different recording optionsDVR may take a few moments to load the settings To set the schedulesExternal Alarm Mode Alarm Display ModeEvent LOG Setup Video Loss DetectTo Setup the Event Log Buzzer Time SetupRelay Time Setup To return to the Menu and save your settingsTo Setup the Relay Time Setup Hard Disk Management SetupOverwrite Mode To Set the DVR to Warn You When the HDD is Getting FullHDD Format Setup To Setup the Password ProtectHDD Information HDD Information will Show YouTerms Network SetupTo Format the HDD To Change from Static to Dhcp Addresses SettingsTo Setup PPPoE Settings Rtsp To Setup your DdnsMail Function and Setup Mail Server UsernameFTP Setup If you receive an email from the DVR it will includeTo Backup Saved Video Footage USB BackupTo Setup Backup Recording Backup Setup DVD/CD BackupTo Backup Saved Video Footage with CD/DVD burner DATE/TIME SetupTo Setup the Date and Time Display Setup System TypeKeyboard Lock DVR ID NumberSystem Password Setup Firmware UpgradeLoad Default LanguageDaylight Saving Time Setup Load Setup From USBBackup Setup to USB Live Viewing HDD & USB InformationTo Call up the HDD & USB Information Digital ZoomPlayback Playback ControlsControls are as follows, from left to right Press Stop to exit out of the playback or playback menuPlayback Search by TimeEvent List Search Events are as followsBackup Video Playback How to View Backup Footage from USBBackup buttons are as follows To backup your file to AVISearching for footage Playback buttons are as follows from left to rightNetwork Guide RequirementsFinding your DVR’s IP Address Preparing Your Computer for Viewing the DVRClick Apply Click OK Network GuideMethod 1 Recommended If this is an option MethodViewing Your DVR on Your Computer Username admin Password admin Log in to the DVR Using Internet ExplorerInstalling the ActiveX controls Viewing Your DVR Outside of Your Network Finding Your External IPIf YOU Cannot Connect TestingOnce Successful To Configure the DVR to Work with Ddns Ddns Dynamic DNSDDNS.CAMDDNS.COM DYNDNS.ORG requires a DYNDNS.ORG accountDYNDNS.ORG Account Setup Required if using DYNDNS.ORGUsername admin Password admin To View DVR Through HostnameMode Network Viewing & PlaybackThis is what the online viewing software will look like Network Viewing & Playback Additional Options To back up saved footageDVR Configuration Options System UpdateSystem Information User ManagementLoad Default IP SettingPort Assignment PPPoEFTP Setting Mail & FTPSetting UP Port Forwarding If using the default settings3G Mobile Device Port Forwarding Other OptionsFrom Your Mobile Device Mobile Troubleshooting3G Mobile Device Port Forwarding Sony Ericsson K608i IPhone and iTouch Viewing Mobile Viewing Installation GuideMobile Viewer Application Sony Ericsson K608i Mobile Viewing Installation GuidePress Yes to begin the installation process Click Ok or Allow to allow the connection Name This is arbitrary and can be named to your likingClick Options Click on Connect Disconnect the BlackBerry device from the computer IPhone and iTouch Viewing SafariBlackBerry Bold On the BlackBerry Click Options Click on Connect Troubleshooting Guide Remote Internet connection Too purple, blue, etcMy browser keeps freezing Night vision camerasBoxes DVR SpecificationsBlack and white DVR Specifications Power InputCamera Specifications Camera Specifications MODEL# VU301 CUsing the ONE to Four Port Power Supply with Cameras Wiring DiagramWiring Instructions Camera ManualCamera Drilling Template Networking InformationWEB Server PORTexample Ddns Server example DDNS.DVRLINK.NET