Night Vision, Operating Modes, Scan, Auto

SVAT ELECTRONICS

Now You Can See

Accordingly the DIP switch located on the back of the monitor should be adjusted to reflect the channel in use.

Night Vision

The camera includes 8 built-in IR LEDs, which allow viewing of up to 5 feet in the dark. To turn on the IR LEDs, use the small switch on the side of the camera. Switching it to the moon icon activates night vision, and switching it to the sun icon turns it off.

Sound-Activated Alarm Feature

When the camera detects sound, an audio alert sounds on the monitor. To adjust the sound trigger sensitivity level, adjust the dial labeled trigger located beside the camera's antenna.

Operating Modes

The system can be set to operate in one of 3 modes: SCAN, AUTO or MANUAL. The desired operating mode can be selected using the buttons on the front panel of the monitor.

Scan

Pressing the SCAN button places the system in scan mode. The monitor's screen will go blank (standby mode) while the system continuously scans active cameras. If a camera detects sound above the preset sound trigger level, the monitor will display the camera's picture and the beeper will sound. Four minutes after the last detection, the screen returns to standby mode and the LCD monitor resumes scanning. Press the MANUAL or AUTO button to cancel this mode.

Auto

Pressing the AUTO button places the system into auto mode. In this mode, the system automatically rotates through all active cameras. When a camera detects sound above

GX5201