Oregon ATC-2K VI Quick Start, Battery Installation, Turning the Camera On, Turning the Camera Off

Page 7

VI) Quick Start

Battery Installation

Be careful!! The edge of the base clip is sharp, when unscrewing the cover, make sure the clip is in the same direction as the lens. Observe the following precautions when unscrewing the cover of the camera:

1. Unscrew the cover at the end of the unit. 2. Place your finger on the 'lip', which is on the bottom half of the rear of the unit, and pull in an upward

direction to open the battery slot door. 3. Insert 2 x AA alkaline batteries into the battery slot

with the polarity in the direction as shown.

4. Close the battery slot door and screw on the end of unit cover.

Important: When the battery is low, the low battery icon will appear on the LCD display.

Always upload video footage to your PC prior to replacing batteries to avoid memory loss

Note: a) Battery installation should be done under adult supervision. b) Do not mix old and new batteries together. Replace

both batteries at the same time. c) Remove the batteries if the camera is not going to be used for long periods of time. This will save battery

11 life.

d)Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. Only batteries of the same or equivalent type as recommended are to be used together.

e)Non-rechargeable batteries are not to be recharged.

f)Rechargeable batteries are to be removed from the camera before being charged.

g)Rechargeable batteries are only to be charged under adult supervision.

h)Exhausted batteries are to be removed from the camera.

i)The supply terminals are not to be short-circuited.

Turning the Camera On

Press and hold the for 2 seconds (two beeping sounds). The LCD display will light up.

For your safety, do not press any buttons on the camera during sports activities.

Turning the Camera Off

1. Press and hold the for 2 seconds (two beeping sounds). The LCD display will turn off.

2. The camera will be turned off automatically after 30 minutes of not being used unless it is in USB mode.

12

Image 7
Contents Dear customer Waterproof Feature Camera PrecautionsCold Weather Product Accessories III Computer System Requirements II Technical SpecificationsMinimum System Requirements IV Camera Description Fixing the position of the camera Mounting the camera using the velcro strapMounting the camera using the handlebar grip Camera Mounting DescriptionTurning the Camera Off Battery InstallationVI Quick Start Turning the Camera OnTaking Video Footage Inserting/Removing the SD memory CardInsert RemoveDifferent mode icons are shown in the table below VII Menu SettingsFrame rate fps Resolution 640 x 480, 320 x 240, 160 x 120 pixels resolutionDeleting video footage Setting Date/Time Clock SetSetting the Year Sound RecordingSD Memory Card Setting the MonthSetting the Day Setting the TimeAvailable Recording Time Viii Connecting to PCTheres no display TroubleshootingIX Playing back video footage on a TV ATC-2K WebsiteRemaining time is not accurate Troubleshooting Cant capture the video footageCant play the video footage on my television Page Oregon Scientific, Inc