Victor GZ-MC100 instruction manual Troubleshooting, Playback, Advanced features

				REFERENCES EN 33
		Troubleshooting		When the screen is under direct sunlight during
				shooting, the screen becomes red or black for an
				instant.
If the problem still exists after following the instructions
				● This is not a malfunction.
below, please consult your nearest JVC dealer.				During recording, the date/time does not appear.
				● [DATE/TIME] is set to [OFF].
The camera is a microcomputer-controlled device.
				HSet [DATE/TIME] to [ON]. ( pg. 18)
External noise and interference (from a TV, a radio, etc.)
might prevent it from functioning properly. In such cases,				The LCD monitor indications blink.
first disconnect its power supply unit (battery pack, AC				● Certain modes of wipe/fader, program AE, effect, DIS and
adapter, etc.) and wait a few minutes; and then re-				other functions that cannot be used together are selected at
				the same time.
connect it and proceed as usual from the beginning.
				Digital zoom does not work.
		Power
				● [ZOOM] is set to [10X] (optical zoom).
				HSet [ZOOM] to [40X] or [200X]. ( pg. 28)
No power is supplied.
				Playback
● The power is not connected properly.
HConnect the AC Adapter securely. ( pg. 14)
				Playback cannot be performed.
● The battery pack is not attached firmly.
				● Recording medium is not selected properly.
HDetach the battery pack once again and re-attach it firmly.
				HSelect the recording medium. ( pg. 17)
	( pg. 14)
				● The rear panel is open.
● The battery is dead.
				HClose the cover and set the power switch to OFF, then to
HReplace the dead battery with a fully charged one.
			.
	( pg. 14)
				● Playback starts, but there is no picture on TV.
		Recording
				HSet the TV's input mode or channel appropriate for video
				playback.

Recording cannot be performed.

●[MEMORY CARD IS FULL] appears.

HReplace with new recording medium or delete unnecessary files. (
pg. 16, 29)

●Recording medium is not selected properly. HSelect the recording medium. (
pg. 17)

●The rear panel is open.

HClose the cover and set the power switch to OFF, then to

.

When shooting a subject illuminated by bright light, vertical lines appear.

●This is not a malfunction.

Advanced features

The focus does not adjust automatically.

●Focus is set to the manual mode.

HSet focus to the automatic mode. (
pg. 31)

●The lens is dirty or covered with condensation.

HClean the lens and check the focus again. (
pg. 32)

The color of the image looks strange.

●The light source or the subject does not include white. Or there are various different light sources behind the subject.

HTry manual white balance adjustment. (Refer to the advanced operation manual in CD-ROM.
pg. 32)

REFERENCES