Ampeg SVP1600 manual Operation Stereo Mode, System Block Diagram

SVP1600 Stereo Bass Power Amplifier

Operation: Stereo Mode:

7	43565	15531SVP16009 SVP1600
	(21)	SERIAL# BMCDN20083
Line: 120V Freq: 60 Pwr: 1.4kVA
		OUT

STEREO/	FROM STEREO PREAMP OR
DUAL MONO	STEREO EFFECT'S LEFT OUTPUT

FROM STEREO PREAMP OR

STEREO EFFECT'S RIGHT OUTPUT

RIGHT CHANNEL CABINET(S)

LEFT CHANNEL CABINET(S)

2 OHMS	2 OHMS
MINIMUM	MINIMUM

Set the Stereo/Dual Mono / Mono Bridge switch to the Stereo/Dual Mono position (switch out).

Connect a shielded signal cable from the Left Output of your Stereo Preamp or Stereo Effect to the Power Amp A Power Amp Input jack. Connect a shielded signal cable from the Right Output of your Stereo Preamp or Stereo Effect to the Power Amp B Power Amp Input jack. Connect a speaker cable from the SVP1600’s Power Amp A Speaker Output jack to the input jack(s) of the Left Channel speaker(s). Connect a speaker cable from the SVP1600’s Power Amp B Speaker Output jack to the input jack(s) of the Right Channel speaker(s).

NOTE: The Speakon® cable must be wired as follows: 1+ = hot, 1- = ground.

System Block Diagram:

POWER AMP A INPUT / MONO

POWER AMP A PARALLEL OUTPUT

LIMIT DEFEAT

POWER AMP B INPUT

LIMIT

LED

A

POWER AMP B	POWER
	A
PARALLEL
OUTPUT	LIMITER

SENSITIVITY

CHANNEL A

	MONO	LIMIT
		LED
SENSITIVITY	BRIDGE
		B
CHANNEL B		POWER
	STEREO/	B
		LIMITER
	DUAL MONO

SPEAKER

OUTPUT A

SPEAKER 1+ SPEAKON®

OUTPUT A 1- 2- SPEAKER

2+ OUTPUT A

	1+					SPEAKON®
	1-		2	-
						SPEAKER
SPEAKER		2+
						OUTPUT
OUTPUT B						MONO BRIDGE
SPEAKER
OUTPUT B
	1+				SPEAKON		®
	1-		2- SPEAKER					7
		2+			OUTPUT B