Menu Setup
Motion Setup
•SENSITIVITY - Sets the Motion Sensitivity. Press the ⇑ ⇓ buttons to navigate, and press the ⇐ ⇒ buttons to set the values (min~max).
•VELOCITY - Sets the Motion Velocity. Press the ⇑ ⇓ buttons to navigate, and press the ⇐ ⇒ buttons to set the values (min~max).
•MASKING AREA - Turns on MASKING
for the specified area (by X,Y axis). Press the ⇑ ⇓ buttons to navigate, and press the ⇐ ⇒ buttons to set the values.
•Press the MENU button to EXIT. All settings will be saved.
MOTION SETUP
| CAMERA 1 | DETECTION TIME |
|
| ||
|
|
|
|
| ||
|
|
| ALWAYS ON |
|
| |
|
|
| ON: 00:00 |
|
| |
|
|
| OFF: 13:00 |
|
| |
|
|
| SENSITIVITY: 0 |
|
| |
|
|
| VELOCITY: 0 |
|
| |
|
|
| MASKING AREA |
|
| |
|
|
| X,Y (00,00) |
|
| |
|
|
|
|
|
|
|
|
|
|
| ADJUST |
|
|
| ⇑⇓ | SELECT | ⇐ ⇒ | MENU | EXIT | |
|
|
|
|
|
|
|
Event Setup
Configuration for Alarm Reporting:
•ALARM - A report is generated when the power is turned ON
•LOSS - A report is generated when a camera has Signal Loss.
•MOTION - A report is generated when a camera detects motion.
•BUZZER HOLD TIME - Sets the audible buzzer time (when motion is detected) between 0~99 seconds.
•REPORT HOLD TIME - Enables or Disables the Report Hold time from 0~99 seconds
•ALARM POLARITY - Reports on the Power On Alarm. Check off all 4 Alarm Boxes, and set the POLARITY to HIGH. If the POLARITY is set to LOW, the POWER ON ALARM will not function.
EVENT REPORT
BUZZER / REPORT CONTROL
CHANNEL 1 2 3 4
ALARM
LOSS
MOTION
BUZZER HOLD TIME: 01 SEC
REPORT HOLD TIME: 01 SEC
ALARM POLARITY: LOW
⇐⇑⇓⇒ SELECT ENTER DISABLE MENU EXIT
20