LOREX Technology LW2201 instruction manual On-Screen Display, Quad split-screen view

Page 13

On-Screen Display

On-Screen Display

1.Signal Indicator – The signal indicator shows the strength of the signal being received from the camera.

The number of bars in the Signal Indicator shows the strength of the signal – One or No Bars indicates the signal is poor, and 4 bars indicate a very strong signal.

Note: Signal Indicator not shown while in Quad Mode.

ATTENTION: If signal is low (e.g. 1 or 2 bars) adjust the antennas, or reposition the cameras or receiver for best performance.

2.Channel Indicator – Displays the current channel number. Press the Pair button on the Receiver to switch between available cameras.

Note: Channel Indicator not shown while in Quad Mode.

CH 1

 

CH 2

 

 

 

CH 3

 

CH 4

 

 

 

 

 

 

3.Status Indicator – The Status indicator message “Connecting” appears when the receiver is trying to locate a camera.

Note: There may be temporary signal losses for less than 1 second, due to the connection retrieval process between the Camera and Receiver (when switching between channels). This normal and should not be considered a defect.

1 2

Figure 4.0 On-screen display

Figure 4.1 Quad split-screen view

3

Figure 4.2 Connecting message

13

Image 13
Contents Ultra Digital Wireless Surveillance System Important Safeguards Installation Important SafeguardsUse ServiceFCC Class B Notice General PrecautionsReceiver Features FeaturesCamera Features Table of Contents Getting Started Rear Panel Wireless ReceiverAttach stand to mounting surface Installing the CameraConnecting the Camera Setting up the Wireless ReceiverInstallation Warnings Auto Viewing ModesQuad split-screen view On-Screen DisplayAdding Cameras Using Auto-ScanSetting Dwell Time Problem Solution TroubleshootingReceiver Specifications Appendix a System SpecificationsAppendix B About Digital Wireless Technology Page ¡Todo aparece sobre el Internet