LOREX Technology LW2201 instruction manual Setting Dwell Time

Page 15

Setting Dwell Time

Setting Dwell Time

You can set the length of time (in seconds) that the receiver displays channels while in Auto Scan.

To set dwell time:

1.Make sure the Wireless Receiver and cameras are fully connected and powered on.

2.Press and hold the VGA/QVGA button and Pair button at the same until the Dwell Time screen appears. Continue holding both buttons.

3.With the Pair button and VGA/QVGA button held down, the receiver will automatically cycle the dwell time from 1~20 seconds. The higher the dwell time, the longer each channel remains on- screen during Auto-Scan.

4.Release both buttons to set the desired dwell time.

Note: If you repeat this process, the Dwell Time screen will display the last set dwell time.

Figure 7.0 Press and hold the VGA/QVGA and Pair buttons at the same time

Figure 7.1 Continue holding both buttons to set the dwell time for Auto Scan

15

Image 15
Contents Ultra Digital Wireless Surveillance System Important Safeguards Installation Important SafeguardsUse ServiceFCC Class B Notice General PrecautionsFeatures Receiver FeaturesCamera Features Table of Contents Getting Started Rear Panel Wireless ReceiverAttach stand to mounting surface Installing the CameraSetting up the Wireless Receiver Connecting the CameraInstallation Warnings Auto Viewing ModesQuad split-screen view On-Screen DisplayAdding Cameras Using Auto-ScanSetting Dwell Time Problem Solution TroubleshootingReceiver Specifications Appendix a System SpecificationsAppendix B About Digital Wireless Technology Page ¡Todo aparece sobre el Internet