Vivotek PT3122 manual Application setup, Weekly Schedule, Event operation

Page 36

Application setup

Weekly Schedule

“Sun” ~ “Sat” Select the days of the week to perform the following operations.

“Snapshots begin at” Set the time to start operations. “Snapshots stop at” Set the time to stop operations.

Setting identical begin time and stop time means 24-hour operation.

Event operation

“Delay second(s) before detecting next event” Set the time delay before restarting to check on the triggering condition when the current condition is triggered. “Take snapshots at second(s) after event” After the camera has taken a snapshot when a condition is triggered, another snapshot will be taken after this configured interval, in seconds.

“Trigger condition” There are four conditions relative to the digital input and the three windows for motion detection. More than one condition can be selected at once. Select the appropriate digital input condition that suits the characteristics of the external device. “high”, “low” selects level-triggering via external voltage input. “rising”, “falling” is for edge-triggering. There are three windows for motion detection each can be assigned a name. If motion detection has not been set up, “undefined” will be shown instead of the window title. If this happens, clicking on “Motion detection” and a note will show to direct the User to the configuration page for motion detection.

“Trigger action” There are four options for two types of action. More than one condition can be selected at once. While choosing to trigger an output alarm, the digital output will short both pins and complete the external device’s circuit. The normal state is open. Either email or FTP can be used to command uploading snapshots. The snapshot names will be “vpre.jpg”, “vtrg.jpg”, and “vpos.jpg”, respectively. They

- 35 -

www.vivotek.com

T:886-2-82455282

F:886-2-82455532

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Page Before You Use This Product Table of Contents 886-2-82455282 886-2-82455532 Package Contents Installation Hardware InstallationSoftware Installation 886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 Initial Access to the Network Camera Check Network SettingsAdd Password to prevent Unauthorized Access How to Use AuthenticationInstalling Plug-in Primary User’s Capabilities Main Screen with Camera ViewConfiguration Camera viewPan/tilt control buttons Client Settings Url http//Network Camera/protocol.html Administrator’s Capabilities Fine-tuning for Best PerformanceFor Best Real-time Video Images Somewhere Between Real-time and Clear Images Only Quality Images Will Do886-2-82455282 886-2-82455532 Opening accounts for new users Building a multimedia web attraction site886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 Building a security application Send snapshots when motion is detected Software revision upgrade Definitions in Configuration System parameters User group administration Network settings SmtpFTP Http StreamingVideo codec parameters 886-2-82455282 886-2-82455532 Motion detection Application setup Weekly ScheduleEvent operation Sequential operation Camera Control Camera control areaPreset function area UPnP and Ddns Settings Remote controller Factory default Viewing system logViewing system parameters Troubleshooting AppendixFrequently asked questions 886-2-82455282 886-2-82455532 886-2-82455282 886-2-82455532 URL commands of the Network Camera Capture update Snapshot of Jpeg imageRestore factory default settings Query status of the digital inputRestart system URL System resource URLGeneral format of command URL System configuration URLSecurity configuration URL Network configuration URL886-2-82455282 886-2-82455532 Ddns & UPnP configuration URL Audio/Video configuration URL886-2-82455282 886-2-82455532 Camera control URL Image quality configuration URL Application configuration URLSeconds interval for sequential mode Technical specifications System MicrophoneElectromagnetic Compatibility EMC Liability
Top Page Image Contents