Vivotek IP3112/IP3122 manual Installation, Hardware installation

Page 8

Installation

Hardware installation

Please verify that your product package contains all the accessories listed in the foregoing Package Contents. Depending on the user’s application, an Ethernet cable may be needed. The Ethernet cable should meet the specs of UTP Category 5 and not exceed 100 meters in length.

Connect the power adapter jack to the Network Camera before plugging in to the power socket. This will reduce the risk of accidental electric shock.

Upon powering up, the device runs through a self-test procedure and the front LEDs will blink between green and red a few times. If self-test passes, the LED will be green and the Network Camera will standby for getting IP address. After getting IP Address, the LED will blink green every second. If self-test fails the red LED will blink several times. Refer to Appendix A for troubleshooting.

The Network Camera provides a general I/O terminal block with one digital input and one relay switch for device control. Pin 1 and pin 2 can be connected to an external sensor device and the state of voltage will be monitored from the initial state 'LOW'. The relay switch of pin 3 and pin 4 can be used to turn on or off the external device.

Consult with the dealer of the peripherals for correct installation.

1	DI-	INPUT (Initial state of DI is low)
2	DI+	INPUT (Max. 50mA, 12VDC)

3SW_COMMON OUTPUT (open from SW_OPEN at initial state) (close with SW_OPEN when set DO to ON)

4 SW_NOPEN

OUTPUT (Max. 1A, 24VDC or 0.5A, 125VAC

- 7 -

www.vivotek.com

Image 8

Contents Page Technical@vivotek.com Before You Use This Product Table of Contents Http 886-2-82455282 886-2-82455532 Package Contents Installation Hardware installationCheck Network Settings Software installationInitial Access to the Network Camera Add Password to prevent Unauthorized Access How to Use AuthenticationInstalling plug-in Primary user’s capability Main Screen with Camera ViewSnapshot Digital ZoomDigital Output Client settings Url http//Network Camera/protocol.html For Best Real-time Video Images Administrator’s capabilityFine-tuning for Best Performance Somewhere Between Real-time and Clear Images Only Quality Images Will DoProtect Network Camera by passwords Opening accounts for new usersMore flexible options for viewers How to change the subject text of homepageChange homepage layout How to change the font color How to change the backgroundPage Page Page How to design my own homepage to replace the current one Page Build a multimedia web attraction site Demo on multiple sites mid-scale serviceProduct demo for e-business large-scale service Page Page Image URL Build a security application Send snapshots when motion is detected Page Software revision upgrade Definitions in Configuration System parameters Security settings Network settings GeneralFTP Streaming Ddns and UPnP settings Video codec parameters Page Motion detection Event operation Application settingsWeekly schedule Sequential operation Homepage layout settings Viewing system parameters Factory defaultViewing system log Status LED TroubleshootingReset and restore Frequently asked questions Page Page URL commands of the Network Camera Capture update Snapshot of Jpeg imageRestore factory default settings Query status of the digital inputRestart system URL System resource URLGeneral format of command URL System configuration URLSecurity configuration URL Network configuration URLPassword for secondary Smtp server Ddns & UPnP configuration URL Video configuration URL Image quality configuration URL Application configuration URL Homepage layout configuration URL Technical specifications NetworkingElectromagnetic Compatibility EMC Liability