AGFA DC-533 user manual Appendix, Troubleshooting, Problem Cause, Solution

Appendix

Troubleshooting

Problem	Cause
Power does not turn on.	Battery is inserted in the
	wrong direction.
	Batteries are dead.
	The battery compartment
	door is open.
The camera does not take	The flash is charging.
pictures.
	Memory is full.
	Memory card is not
	formatted correctly.
Image is not recorded when	The Flash is charge.
the shutter button is
	Memory is full.
pressed.
The flash does not fire	Flash is set to OFF.
Image is blurry or out of	The camera was moving
focus.	when the image was
	captured.
	The subject was beyond
	the range within which
	the camera can focus.

Image is not displayed on	A memory card with
the LCD monitor.	non-DCIF images
	(recorded with other
	camera) is loaded.
Recorded images are not	The camera was turned
saved in memory.	off/powered down before
	the image was stored in
	memory
Cannot transfer images to	USB driver is not
a computer after	installed.
connecting the USB cable.

Solution

Reload battery in the correct direction.

Replace or recharge batteries. Make sure the battery compartment door is securely closed.

Wait for the flash to charge. Insert a new memory card.

The card may be detective, use a new card.

Wait for the flash to charge. Insert a new memory card.

Set the flash to any mode except off.

Hold the camera steady when shooting picture.

Turn the Macro mode on it the subject is within 5 cm (zoom out) or 50 cm (zoom in).

Do not use Macro mode when shooting distant subjects. This camera cannot display non-DCIF images.

If the battery low indicator appears on the LCD monitor, replace the battery immediately.

Install the USB driver before you connect the camera to a computer / turn the camera on.

- 49 -