Kodak 805 manual Guide bar Heater line

2.Use a lint-free cloth moistened with isopropyl alcohol or distilled water to clean the print head, and wipe along the heater line four times:

•Wipe the full length of the area (always in one direction).

•Use a clean part of the cloth for each wipe.

•Apply firm, even pressure.

•Wipe only the following areas.

Guide bar

Heater line

3.Allow the wiped area to dry for about two minutes.

4.Close the top cover and turn on the printer.

5.Make a test print.

NOTE: It may be necessary to repeat Steps 1- 5 several times to remove any artifacts. If you cannot remove the artifacts, call for service.

CONTENTS SEARCH HELP

Introduction

Setting up the Printer

Operating the Printer

Troubleshooting

Site Specifications

Accessories and

Supplies