Epson 1280 manual Installing the Clip

Page 13

Sawgrass Technologies, Inc. SubliJet IQ® Getting Started Guide for the EPSON Stylus Photo 1280

11.Clean the printer and the bottom of the rubber bumpers with the

alcohol pad provided and attach the Velcro circles to the bumper and to the printer. Push them firmly into place.

NOTE: Do not put the left bumper on the overhang of the printer interior. The weight of the lid can push down causing the overhang to contact the QuickConnect tubing.

Installing the Clip

12.Once the QuickConnect is installed properly, remove the paper back from the adhesive strip and stick firmly against the side of the black cartridge holder lid. Press the tab to open the clip. See Fig 11.

Fig. 11

13.Pull the tubing flush into the clip. Ensure the tubing is not pinched in any way as to constrict ink flow. See Fig 12.

Fig. 12

9

Image 13

Contents For Epson Stylusâ Photo SubliJet IQPage SubliJet IQä Important Read Carefully Table of Contents Introduction About this Document QuickConnect System ContentsInstalling the QuickConnect ink bags Setting up the QuickConnect SystemPage Installing the QuickConnect Cartridges inside the printer Page Page Installing the Clip Priming the QuickConnect cartridges and tubing with ink Select StartSettingsPrintersSelect StartControl PanelPrinters and Faxes Page Transporting the printer with QuickConnect Replacing an Empty Ink bagTips for Using QuickConnect System Selecting Paper Using PowerDriver IQTransfer Time Surface Temp Pressure Remarks Sublijet Heat Transfer InstructionsTips for Metal Tips for Polyester FabricTips for Ceramic Tiles and Mugs Tips for Hanes Soft L’Inkâ Shirts Moisture and Humidity ProblemsSupplies & Equipment Storage Colors in my transferred image are incorrect TroubleshootingColors are light and splotchy Technical Support Page Page Page Page