Sony HDR-SR11E, HDR-SR12 Disassembly, Discharging of the ST-185 BOARD’S Charging Capacitor C5006

2. DISASSEMBLY

NOTE FOR REPAIR

•Make sure that the flat cable and flexible board are not cracked of bent at the terminal. Do not insert the cable insufficiently nor crookedly.

•When remove a connector, don’t pull at wire of connector. It is possible that a wire is snapped.

•When installing a connector, don’t press down at wire of connector. It is possible that a wire is snapped.

Cut and remove the part of gilt which comes off at the point. (Be careful or some

pieces of gilt may be left inside)

DISCHARGING OF THE ST-185 BOARD’S CHARGING CAPACITOR (C5006)

The charging capacitor (C5006) of the ST-185 board is charged up to the maximum 330 V potential.

There is a danger of electric shock by this high voltage when the capacitor is handled by hand. The electric shock is caused by the charged voltage which is kept without discharging when the main power of the unit is simply turned off. Therefore, the remaining voltage must be discharged as described below.

Note: High-voltage cautions

Discharging the Capacitor Short-circuit between the two points with the short jig about 10 seconds.

Preparing the Short Jig

To preparing the short jig, a small clip is attached to each end of a resistor of 1 kΩ /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to prevent electrical shock.

1 kΩ/1 W

Wrap insulating tape.

ST-185 Board

R:1 kΩ/1 W

(Part code: 1-215-869-11)

C5006

NOTE FOR DISCONNECTING THE HARNESS (COAXIAL CABLE)

When disconnecting the harness (COAXIAL CABLE), do not pull the harness part but pull off the connector body with tweezers etc.

Harness (coaxial cable)

Tweezers etc.

HDR-SR11/SR11E/SR12/SR12E_L2

2-1