Harmony House JT50, JT100 manual Important Safety Instructions

Page 2

IMPORTANT SAFETY INSTRUCTIONS

The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products.The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit.The exclama- tion point in an equilateral triangle indicates that it is necessary for the user to refer to the owner’s manual.

These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all servicing to quali- fied personnel. Opening the chassis for any reason will void the manufacturer’s warran- ty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage.

U.K. MAINS PLUG WARNING

A moulded mains plug that has been cut off from the cord is unsafe. Discard the mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUMSTANCES

SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13

AMP POWER SOCKET. Do not use the mains plug without the fuse cover in place. Replacement fuse covers can be obtained from your local retailer. Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following code:

GREEN and YELLOW - Earth

BLUE - Neutral

BROWN - Live

As colours of the cores in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The core which is coloured green and yellow must be connected to the termi- nal in the plug marked with the letter E, or with the earth symbol, or coloured green, or green and yellow.

The core which is coloured blue must be connected to the terminal marked N or coloured black.

The core which is coloured brown must be connected to the terminal marked L or coloured red.

This equipment may require the use of a different line cord, attachment plug, or both, depending on the available power source at installation. If the attachment plug needs to be changed, refer servicing to qualified service personnel who should refer to the table below. The green/yellow wire shall be connected directly to the unit's chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit or in the system to which it is connected can result in full line voltage between chassis and earth ground. Severe injury or death can then result if the chassis and earth ground are touched simultaneously.

WARNING

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

KEEP THESE INSTRUCTIONS

HEED ALL WARNINGS

FOLLOW ALL INSTRUCTIONS

CLEAN ONLY WITH A DAMP CLOTH

DO NOT BLOCK ANY OF THE VENTILATION OPENINGS, INSTALL IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS.

DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES; OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.

ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFAC- TURER.

UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTA-

CLE: Replace fuse with same type and rating only.

MULTIPLE VOLTAGE INPUT: This equipment may require the use of a different line cord, attachment plug, or both, depending on the available power source at installation. Connect this equipment only to the power source indicated on the equipment rear panel.To reduce the risk of fire or electric shock, refer servicing to qualified service personnel or equivalent.

ELECTROMAGNETIC COMPATIBILITY

This unit conforms to the Product Specifications noted on the Declaration of Conformity. Operation is subject to the following two conditions:

this device may not cause harmful interference, and

this device must accept any interference received, including interference that may cause undesired operation. Operation of this unit within significant elec- tromagnetic fields should be avoided.

use only shielded interconnecting cables.

LITHIUM BATTERY WARNING

CAUTION!

This product may contain a lithium battery.There is danger of explosion if the battery is incorrectly replaced. Replace only with an Eveready CR 2032 or equivalent. Make sure the battery is installed with the correct polarity. Discard used batteries according to manufacturer’s instructions.

ADVARSEL!

Lithiumbatteri - Eksplosjonsfare.Ved utskifting benyttes kun batteri som anbefalt av apparatfabrikanten. Brukt batteri returneres apparatleverandøren.

ADVARSEL!

Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri av samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.

VAROITUS!

Paristo voi räjähtää, jos se on virheellisesti asennettu.Vaihda paristo ainoastaan laite- valmistajan suosittelemaan tyyppin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.

VARNING!

Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.

I

Image 2
Contents User’s Guide Important Safety Instructions Declaration of Conformity Table of Contents Mirage JT50/JT100 Features IntroductionQuick Start Optional Foot Controller ConnectionsGuided Tour of the Mirage JT50/JT100 Top PanelRear Panel Amp Section Preset SectionAbout the Mirage JT50/JT100 Effects SectionMaking Connections Using the Mirage JT50/JT100Getting Started Plug and PlaySelecting a Preset Creating or Editing a PresetPowering the JT50/JT100 Selecting an Amp ModelModulation/Pitch Shifting Effects Adjusting the Amp ControlsAdding Effects Noise Gate DelayAdjusting the Gate Threshold VibratoReverb Storing/Copying a PresetTo store or copy a preset Hall ReverbBank Foot Switches Effect Foot SwitchesPreset Foot Switches Other FunctionsExpression Pedal J8 Expression Pedal CalibrationTuner Resetting the Mirage JT50/JT100 Effects LoopMirage Factory Preset List AppendixJohnson Mirage User’s Guide Section Four Appendix

JT100, JT50 specifications

Harmony House is a renowned name in the world of home automation, and their latest offerings, the JT50 and JT100, are setting new standards in comfort, connectivity, and control. These innovative home systems seamlessly integrate smart technologies to create a harmonious living environment that caters to modern lifestyles.

The Harmony House JT50 is designed for mid-sized homes, providing an intuitive smart home experience. One of its standout features is the integrated voice control system, which allows residents to operate various appliances, lighting, and climate controls hands-free. The JT50 is equipped with smart sensors that monitor temperature, humidity, and even air quality, ensuring that the home environment is not only comfortable but also healthy.

Moreover, the JT50 employs energy-efficient technologies, including smart thermostats that learn the homeowner’s schedule and adjust settings accordingly to save energy without sacrificing comfort. The system can also optimize energy usage by scheduling appliances to run during off-peak hours, contributing to lower utility bills.

In contrast, the Harmony House JT100 is suitable for larger residences and offers expanded capabilities. This advanced model includes all the features of the JT50 but adds a more robust security framework. The JT100 supports advanced surveillance cameras and alarm systems that can be monitored in real-time from a smartphone or tablet. Additionally, it features facial recognition technology to enhance home security and ensure that only recognized individuals can access the premises.

Both models are compatible with a variety of smart home devices, allowing users to customize their systems according to their preferences. From smart lighting to automated window treatments, the possibilities are endless. The user interface is designed to be user-friendly, making it accessible for all family members, regardless of their tech-savviness.

Furthermore, both the JT50 and JT100 come with Harmony House’s mobile app, which provides full control over the home automation system from anywhere. Through the app, users can receive notifications, monitor energy usage, and even set up custom automation routines that adjust settings based on the time of day or the homeowner’s presence.

In summary, the Harmony House JT50 and JT100 bring a new level of convenience and security to modern living. With their emphasis on smart technology, energy efficiency, and user-friendly design, these systems are perfect for anyone looking to enhance their home environment while embracing the benefits of automation. Whether you choose the compact JT50 or the advanced JT100, you are investing in a future where comfort and technology work hand in hand.