Functions (Front Panel) | 2 | 3 | 1 |
4 | |||
|
|
| 13 |
15 |
|
| 11 |
|
|
| |
10 |
|
| 12 |
5a |
|
| 8 |
|
|
| |
|
|
| 5b |
|
|
| 14 |
6 |
|
| 7 |
|
|
| |
9 |
|
|
|
(1)POWER SWITCH - Red LED will light when power is ON.
(2) MASTER LEVEL - Dual LED's show the level of the left and right master output.
(3)GAIN CONTROL - Used to set the level of the input signal for its designated channel.
(4)BASS/MID/TREBLE CONTROL - Used to increase or decrease the LOW's, MID’s, and HI’s of the input signal. The
(5a) CHANNEL 1 TRANSFORMER SWITCH (CHANGEABLE) - Used to select the input to be sent to channel 1. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see diagram on page 7.
(5b) CHANNEL 2 TRANSFORMER SWITCH. (CHANGEABLE) - Used to select the input to be sent to channel 2. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see diagram on page 7.
(6)CHANNEL FADER - Used to adjust the output level of each channel.
(7)FADER CURVE SWITCH - Changes Feather Fader™ Crossfader from a NORMAL CURVE to a QUICK CURVE (used for crabbing).
(8)PFL/CUE BUTTONS - Use the PFL
(9)FEATHER FADER™ CROSSFADER - Mixes the signals of channel 1 and channel 2. When the crossfader is set in the center position, both channels can be heard at once.