Inputs and Outputs lRear Panel) Cont.
(16)GND (GROUND TERMINALS) - Connect the ground lead of the turntables with this terminal. This helps to reduce humming and popping noises.
(17), (18) LINE / PHONO / AUX INPUT JACKS - Input jack for
(19)PHONO / AUX SELECTOR SWITCH - Changes phono to an extra line; allows the DJ to use a CD player or other input device in the same line as the phono line. When using a turntable select PHONO, and when using other input devices select AUX. PHONO/AUX lines can be used with LINES 1 and 2. The PHONO /AUX SELECTOR SWITCH gives the DJ the possibilities of 4 inputs lines (ie. 4 lines CD, tape etc.; or 2 lines CD, tape etc. and 2 phono lines).
(20)REC OUT - Connect to your record unit. The REC OUT level is not influenced by the master control (13).
(21)MASTER OUT - Parallel output of P.A. output. Connect with the input of a power amplifier.
(22)MIC JACK - Connect your microphone with 1/4 inch (6.3mm) jack plug here. The signals may be controlled by
the DJ MIC CONTROL KNOB (15). BASS & TREBLE can be adjusted by the DJ MIC BASS CONTROL KNOB (15) and the DJ MIC TREBLE CONTROL KNOB (15).
(23)FUSE - Fuseholder. Only replace the fuse when the device is disconnected from main power supply. Only replace with fuses of the same power and rating.
(24)AC CONNECTION - Standard IEC plug with detachable AC power cord.
(25)AC VOLTAGE SELECTOR - Select between 115V/5OHz or 230V/6OHz. Make sure that the selector is set to the proper voltage you are using.
Replacing the Crossfader
•Disconnect from main power supply
•Remove the fader knob.
• Remove the two outer screws.
• Take the fader out and unplug the connection cable.
• Connect the new fader and replace back into mixer.
Changing the Transformer Switch
•Disconnect from main power supply.
•Unscrew 2 larger Philips screws (see arrow on diagram at the right).
•Move switch to desired position.
•Reinstall screws.
➔
➔