FujiFilm DL270 owner manual Switching back to 35 mm full size mode, Zooming to telephoto

Page 13

5. Switching back to 35 mm full size mode

To switch back to the standard mode, turn off the red “P” in the Finder by pushing the Lens Cover Button back to center position. You can do it without pressing in the Pinhead Button Lock.

6. Zooming to telephoto

To zoom to telephoto, press in the upper Zoom Button. The size of the Finder image will change with the movement of the Lens.

•Do not block the Lens or apply pressure to it while it is zooming.

•If the camera is switched on and ready for shooting but is left idle for five minutes, the Lens will automatically move back to 35 mm wideangle, all the different selected modes will reset them- selves, and all the signs in the LCD will vanish. But you can reset the camera again for shooting by pressing down the Shutter Release or zoom buttons. However, you cannot do it with the Remote Control Switch.

13

Image 13

Contents OWNER,S Manual Special Features ContentsNames of Parts Button Liquid Crystal Display Open the battery compartment cover Load the BatteryInsert the battery Check the loaded battery Attach the Strap Open the camera back Load the FilmInsert the film Close the camera back Check the film tip positionMm full-size mode covering area Turn on the powerTaking Pictures Panorama mode covering area Panorama modeZooming to telephoto Switching back to 35 mm full size modeHold the camera still Zooming to wideanglePress the shutter release about halfway down Aim the autofocus spot at your subjectTake your picture After exposing the last frame END of FilmUnload the exposed film Unloading the film in mid-roll This is the picture you want but Using the Autofocus LockMove the camera slightly While pressing the shutter release about halfway down Word on the camera’s flash exposure modes Selecting the Exposure ModeEffective flash range Taking ordinary pictures Automatic-flash mode in low light Word on red-eye effect Taking non-flash pictures 4. Flash off mode Set the self-timer Using the SELF-TIMERStart the Self-timer Wait 10 secondsRemote control switch Using the Remote Control SwitchTake out the remote control switch Take your remote control picture Set the camera to remote controlCarrying the remote control switch Effective switch rangeFaults Possible Causes Remedies Camera FAULTS, Possible CAUSES, and RemediesFaults Possible Causes Remedies Print FAULTS, Possible CAUSES, and Remedies Camera Care and Cautions Finder SpecificationsPower Source Self-timerOthers Fujifilm Abroad