Zhumell RF645 manual Getting Started

Nomenclature

Lens mounting index

(camera body)

Lens Lock pin

Rangefinder

coupling roller

Electronic contacts

(camera body)

Flash synch terminal

Light shielding curtain

Film type selection lever

Printed circuit cable

Film pressure spring

Light shielding curtain

Film start alignment mark

Lens lock release button

Rear cover

Spool holder

Pressure plate

Film spool shaft lock

release button

1. Getting Started	1-1 Loading Batteries
	The RF645 will not function without batteries loaded.
	1. Appropriate batteries
	Load two CR2 type 3-volt lithium battery cells.
	2. Open the battery chamber cover
	Pull down on the battery chamber lock release and the cover
	will swing open.
	3. Insert batteries
	Insert two cells of the same type of batteries in the same direc-
	tion as shown in drawing, directing the plus (+) side toward the
	inside chamber.
	4. Close the battery chamber cover
	Close the chamber cover and make sure the cover is securely
	locked. A loosely locked cover may open and drop the batter-
	ies in the middle of a shooting session.

6