JVC TK-C1431 manual Motion Detect Screen, Communication Screen, Maintenance Screen

MENU SETTING

MOTION DETECT Screen

Settings are executed about the motion detecting function that emits alarm signals when there exists any motion in the image. Alarm signals are output from the auxiliary terminals on the back.

Item		Functions and set values	Initial value
MODE	This sets ON/OFF of motion detecting function.		OFF
	OFF:	Motion detecting function does not work.
	ON:	Motion detecting function works.
LEVEL	This sets the level that detects motion.		NORMAL
	If the item MODE is set to OFF, “- - -” will appear, and
	settings cannot be changed.
	To function with large signal level change…decrease the
	value
	To function with small signal level change…increase the
	value
	[Set values: –5 to NORMAL to 5]
AREA EDIT	This sets the range in which the motion detecting function		–
	works.
	( Page 39)
ALARM TIME	This sets the output time of the alarm signal output of		10s
	AUX terminal as well as “ALARM” display on the screen
	when motion is detected.
	If the item MODE is set to OFF, “- - -” will appear, and
	settings cannot be changed.
	[Set values: OFF, 5s, 6s, 7s, 8s, 9s, 10s, 15s, 20s, 30s,
	1min]
	MEMO
	Even when the ALARM TIME item is set to OFF, an alarm
	signal is output from the AUX terminal for about 500ms,
	and “ALARM” is not displayed on the screen.
DEMONSTRATION	This is used when checking and confirming the set motion		–
	detecting function. The detection area is shown in gray.
	( Page 39)

COMMUNICATION Screen

Settings are made for the control signal-connecting terminals on the back. If the setting is changed, be absolutely sure to switch on the power again.

Item	Functions and set values	Initial value
STYLE	This sets a communication system according to the system	P TO P
	used.
	P TO P (Point to point)
	This is set when a remote control unit controls a camera.
	M.DROP (Multi-drop)
	This is set when a remote control unit controls a plural
	number of cameras.
MACHINE ID	This is set when the STYLE item is set to M.DROP. This	– – –
	is the number that identifies individual cameras in a group.
	No proper function can be realized if an ID number is
	repeated within a system.
	A combined use with the RM-P2580 necessitates the
	setting together with the video input number of the RM-
	P2580.
	If the item STYLE is set to P TO P, “- - -” will appear, and
	settings cannot be changed.

MAINTENANCE Screen

White spot compensation is performed.

Item	Functions and set values	Initial value
CCD SPOT	The white spots on the screen, which are characteristic	–
	for CCDs can be reduced.
	 Page 42 “White Spot Compensation”

FACTORY SETTINGS Screen

Set values are returned to initial values.

Item		Functions and set values	Initial value
FACTORY	The values set on the menu are returned to initial values.		–
SETTINGS	CANCEL	: No return to the initial value.
	CLEAR	: Returns set values except titles to the
	(WITHOUT TITLE)	initial value.
	CLEAR (ALL)	: Returns all set values including titles
		to the initial value.
	Select respective set value and press the SET button.
	Then, “DATA CLEARED” will appear for about 3 seconds.
	Be sure not to switch off the power while the display is still
	on.
	MEMO
	However, when FACTORY SETTINGS by means of
	transmitted commands, the contents of the
	COMMUNICATION menu do not return to the factory
	settings.

E-34 E-35