JVC GR-DX106/76AG manual Select Scenes, To S/AV, Editing Extension cable provided, To Pause in j

●Make sure to set “S/AV INPUT” to “OFF” in the Menu Screen (
pg. 35).

●When editing on a VCR equipped with a DV input connector, an optional DV cable can be connected instead of an S-Video cable and audio/video cable.

5 If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE s on the remote control (
pg. 28, 43).

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

6 At the beginning of the scene, press EDIT IN/OUT g on the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

7 At the end of the scene, press EDIT IN/OUT g. The Edit-Out position appears in the Random Assemble Editing Menu.

To S/AV &

S-Video/Audio/Video/ Editing cable (provided)

Editing Extension cable (provided)

To Remote PAUSE or R.A.EDIT

To PAUSE IN j
	U
s	D
f	J
g
	h

Connector cover**

To AUDIO, VIDEO* and S-Video connectors

VCR

TV

8 If using a Fade/Wipe at the end of the scene, press FADE/WIPE s (
pg. 28, 43).

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•When you use Fade/Wipe effects, that time is included in the total time.

9 If using Playback Special Effects, press EFFECT f (
pg. 39).

10 Repeat steps 6 through 9 to register additional scenes.

•To change previously registered points, press CANCEL h on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you are not using Fade/Wipe or Programme AE with special effects, repeat steps 6 and 7 only.

NOTES:

● When choosing a scene, set Edit-In and Edit-Out points

so that there is a relatively large difference between

them.

● If the search time for an in-point exceeds 5 minutes, the

recording deck’s Record-Standby mode will be cancelled

and editing will not take place.

● If there are blank portions before or after the Edit-In and

Edit-Out points, a blue screen may be included in the

edited version.

*Connect when the S-Video connection is not used. ** When connecting cables, open this cover.

SELECT SCENES

4 Point the remote control at the camcorder’s remote sensor. Press PLAY (4) D and then press R.A.EDIT ON/OFF J on the remote control.

The Random Assemble Editing Menu appears.

● Since time codes register time only as accurately as

seconds, the time code total time may not match the total

programme time exactly.

● Turning off the camcorder’s power erases all registered

Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from Programme

AE with special effects, you cannot use the Black & White

Fader. In this case the Black & White indicator begins

blinking. Once the next Edit-In point is registered, the

effect is turned off. To combine these effects, use Sepia

or Monotone during recording, then use the Black &

White Fader during Random Assemble Editing.

● It is not possible to use Fade/Wipe effects and

Programme AE with special effects during Random

Assemble Editing using a DV cable.

EN

42 USING THE REMOTE CONTROL UNIT