JVC TK-C210FW manual Mounting the Dome Cover, White-spot correction

Adjusting Image (continued)

Adjusting Images (continued)

‹Registering alarm position

For registering the angle of view during monitoring when there is an alarm input.

4.	ZOOM/FOCUS FAR TELE	L H	[MEMORY] WHT.BAL.	4	4	PHASELL	RESET/[SPOT]
	IRIS	LEVEL		R	B
2.,3.					6
					8
					7
	POSITION SELECT WIDE	NEAR			5
1.,5.			ALARM POSITION		3
				2	2
					1

Mounting the Dome Cover

After setting is complete, mount the dome cover.

Position mark

1.

White-spot correction

As a general characteristic unique to CCDs, white-spots may appear on the screen with age. In order to reduce this phenomenon, this unit is equipped with a white-spot correction feature. Switch on the camera power supply and wait for at least 30 minutes.

(Not available on TK-C210FW)

‹TK-C215V4

RESET/ [SPOT]

[SPOT] button

1. Remove the dome cover.
2.	Cover the lens surface using a black sheet
	of paper, etc. so that light does not enter the
	lens.
3.	Set the function selection switch 8 to
	[SPOT]. (A pg. 11, 13)
4.	Press and hold the SPOT CORRECTION
	button for more than 2 seconds.
● White-spot correction will start. Correction
	may take several seconds for completion.
	NOTE:
	● Maximum correction: less than 16 to 32
	spots
	● The white-spot correction feature of this

1.Check that the [ALARM POSITION] indicator light is turned on.

Registration of alarm position is enabled.

●Press the [POSITION SELECT] button if the [ALARM POSITION] indicator light is off.

2.Adjust the image size. (A pg. 25)

3.Press the [MEMORY] button for 2 seconds or longer.

The [ALARM POSITION] indicator light blinks for 3 times (green)



ALARM position registration is completed

4.Adjust the brightness. (A pg. 25)

5.Press the [POSITION SELECT] button. The camera returns to the home position

NOTE:

●Be sure to return the camera to the home position after registration of the alarm position is completed.

In addition to pressing the [POSITION SELECT] button, you can also use the power ON/OFF button to return the camera to the home position.

●To check images at the registered home position or alarm position, press the [POSITION SELECT] button. Press this button to switch between the image at the home and alarm positions.

1.Mount the dome cover.

Align the position marks on the camera unit and dome cover, followed by pressing in directly to mount the cover.

CAUTION:

Press the dome over until a “click” sound is heard. Check that the cover is firmly mounted. Failure to mount the cover firmly may cause this cover to fall off.

R

B

LLPHASE

1	O
2	N	2
3
		4
4
5		WHT.
6
7		BAL.
8			Function selection switch 8

‹TK-C215V12

ZOOM/FOCUS FAR TELE	L H	[MEMORY] WHT.BAL.	4	4	PHASELL	RESET/[SPOT]	[SPOT] button
IRIS		LEVEL	R	B
				8			Function selection
				7			switch 8
	NEAR			6
POSITION SELECT WIDE				5
		ALARM POSITION		3
			2	2
				1

unit does not guarantee the correction of

all white spots.

Depending on the characteristic of white

spots, correction may not be possible.

● When performing white-spot correction,

accurate data may not be achieved in case

of highly detailed pixels since correction is

made using the information of surrounding

pixels.

● The result of white-spot correction is

maintained until the next correction is

performed.

26 27