Altinex DAV0106-V1A2 manual Technical Specifications, About Your Distribution Amplifier

DISTRIBUTION AMPLIFIERS

cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own

The DAV0106-V1A2receives power from a universal power supply and accepts input from 95 to 240 Volts AC at 50 or 60 Hz.

expense.

TECHNICAL SPECIFICATIONS

3

∙Any changes or modifications to the unit not expressly approved by Altinex, Inc. could void the user’s authority to operate the equipment.

ABOUT YOUR DISTRIBUTION AMPLIFIER 2

The DAV0106-V1A2Distribution Amplifier, a product of exceptional quality and design, consists of video and stereo audio amplifiers.

The video amplifier is designed to provide six buffered and amplified outputs from one input signal. The input and output signals are isolated to prevent ground loops. An additional BNC connector is provided to make the input signal available for additional connections, or to serve as a loop output. The input termination is switch selectable to either be 75 Ohms or unterminated.

The audio amplifier is designed to provide six buffered and amplified outputs for both left and right channels. The input and output signals are isolated to prevent ground loops. The input termination is switch selectable to either be 600 Ohms or high impedance.

The DAV0106-V1A2Distribution Amplifier will allow the connection of video and audio amplifiers simultaneously.

The DAV0106-V1A2Distribution Amplifier is a state-of-the-art product with a bandwidth of 130MHz for video signals, which enables it to remain transparent to the incoming video signals passing through it. It also has a bandwidth of 10Hz to 20kHz for audio signals.

The DAV0106-V1A2can pass NTSC, PAL or SECAM type video signals. The DAV0106-V1A2can drive output signals up to 75 feet or more when it is used with high-quality coaxial cables.

FEATURES/ DESCRIPTION

Compatibility

No of Inputs

Input

Connector

Input Signals

Level

Impedance

Type

No of Outputs

Output

Connector

Output

Signals

Level

Impedance

Type

Gain

Differential Gain/Phase

Frequency Compatibility

Typical

Bandwidth

Flatness

Video

NTSC, PAL,

SECAM,

Composite

Video

1

One BNC

Female

1.7V

75 Ohms or unterminated

Differential input isolated from

GND

6, +1 input loop

Seven BNC

Female

3V p-p max

75 Ohms

Outputs isolated

from GND

0d B

less than 0.02%

@20 IRE, 0.01°

@20 IRE

85 MHz @ -3d B

0.1d B to 30

MHz

Audio

Stereo or Mono

Audio

1

One 3.5 mm

5-pin Terminal

Block

10 V p-p max

600 Ohms or

high impedance

Differential input isolated from

GND

6

Six 3.5mm

Terminal Blocks

10V p-p

Low - drives 600

Ohms

Differential input isolated from

GND

0d B

unbalanced, +6d

Bbalanced

__

10 Hz – 20 kHz

__

3