JVC VN-T216VPRU manual Firm place ceiling slab or channel using a Safety Wire Fall

ŸSecure the camera bottom case (1) to the wall/ceiling with tapping screws, supplied.

ŸAdjust the view angle (zoom, focus, and Horizontal Rotation).

	To prevent the camera from falling off, ensure that it is connected to
	a firm place (ceiling slab or channel) using a Safety Wire (Fall
	Prevention Wire is not supplied).
Warning	Pay also careful attention to the length, strength, wiring, and
	material (insulating properties) of the fall prevention wire to be used.
	The length should be as short as possible within the permissible
	range of the mounting length. The wire should be strong enough to
	withstand the total weight of this product. (Pay also attention to the
	finishing at the end of the wire.)
Caution	Must be isolated camera and the wall/ceiling which are connected
	by the Safety Wire (Fall Prevention Wire).
		Safety Wire
		(Fall Prevention Wire, not supplied)

4S Electrical junction box (Optional)

1.Secure the mounting kit (optional) to 4S Electrical box using 2 appropriate screws.

2.Then secure the camera case to mounting kit using 2 appropriate screws.

3.Tuck the cables in the 4S Electrical box.

4.Adjust the view angle (zoom, focus, and Horizontal Rotation).

5.Attach the camera housing.

6.Turn the power on after you have installed the camera.

12