Trango Broadband Wireless: Essential Guide to Basic Configuration of M900S Router

Basic Configuration via Browser Interface

Configure Basic SU Parameters

In order to establish a working link, the Base ID in the SU must match the Base ID set in the AP.

SU Basic Setup:

1.Connect to the SU (see Getting Started) and open the Configuration page.

2.Set Base ID. (Must match the AP.)

3.Set IP, Subnet, and Gateway, or leave at default settings. Keep in mind, if you change the IP Settings of the radio, you will loose your HTTP session when you Save and Activate Settings.

4.Ensure default Opmode is "ON."

5.Save and Activate Settings.

6.If in Opmode “OFF,” click Activate Opmode.

At this point, if all parameters have been set correctly and the radios are within range, a wireless link between the AP and SU will automatically become established. Once this occurs the SU will be in “associated” status.

Allow approximately 60 seconds for the radios to complete the boot-up cycle and to associate. If the AP is busy servicing many SUs, the association process may take slightly longer.

Trango Broadband Wireless — User Manual M900S Rev. C Page 14