Trango Broadband M900S user manual Basic Configuration via CLI, Access Point Basic Settings

Basic Configuration via CLI

Section 5 Basic Configuration via CLI

This section covers how to utilize the radio’s CLI interface to establish a working wireless link.

In this section the most basic settings using the CLI are discussed. Topics include:

•Access Point Basic Settings

•Subscriber Unit Database Settings

•Subscriber Unit Basic Settings

See Appendix A − Command Set Reference for a complete listing of the CLI commands.

See the “Getting Started” section for a description of how to access the radio via Telnet or Serial Interface.

Access Point Basic Settings

After logging into an AP or SU, it is good practice to type the sysinfo command to see the radio’s basic system information. Example (Access Point):

#> sysinfo

[Hardware Version] 8005

[FPGA Version] 03121104 [Checksum] 75930BDC

[Firmware Version] AP 1p0a2H8005D04010603 [Checksum] AE5D873F [Device ID] 00 01 DE 15 5C D0 [S/N] 01400016

[Base ID] 1234 [AP ID] 01

[System Up Time] 0 day(s) 00:29:56 [Opmode] on [Default Opmode] on

[IP] 10.8.0.254 [Subnet Mask] 255.255.255.0 [Gateway] 10.8.0.1 [Httpd Port] 80 [Httpd Status] listen

[Telnetd Port] 23 [Telnetd Status] connected (10.8.0.62,1146) [Tftpd] disabled

[RF Tx Power] -4 dBm

[RF Rx Threshold] -98 dBm [MIR Threshold] 3 Mbps

[Ch#01] 906 Mhz [Ch#02] 912 Mhz [Ch#03] 918 Mhz [Ch#04] 924 Mhz [Default Channel] 1 h [Active Channel] 1 h

[Broadcast Packet] block [SU to SU] off [TCP/IP for SU] on [Remarks]

[RF Rx] 0 kbps [RF Tx] 0 kbps [Eth Rx] 1 kbps [Eth Tx] 0 kbps

Many of these parameters can be changed by the user. A description of each of these changeable parameters, along with the related command, is shown in the table below.

!Important! When changing settings, it is usually necessary to type the save ss command in order to update the radio’s flash memory. If you do not type the save ss command, the setting will be lost the next time the

radio is rebooted or power cycled.

.

AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS

AP Parameter	Description	Related CLI Command
Device ID	MAC Address of AP	N/A
Base ID	Specifies the cell or cluster to	set baseid <baseid>
	which the AP belongs. Base ID
	must match in AP and SU in	Example:
	order to establish a wireless	#>set baseid aa12
	link.
Trango Broadband Wireless — User Manual M900S Rev C		Page 20