Trango Broadband M900S Set apid apid 00-FF in HEX, Opmode on y, Set defaultopmode on or off

Basic Configuration via CLI

AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS

AP Parameter	Description	Related CLI Command
AP ID	This parameter provides a	set apid <apid> (00-FF in HEX)
	unique number for each AP. If
	Target AP is specified on SU,	Example:
	the SU can only authenticate	#>set apid 33
	with the specified AP. The
	default AP ID is the last two
	bytes of the MAC address.
Opmode	Current Opmode of the radio.	opmode on y
		This sets the radio to Opmode “ON.” If the radio is
		accessed via the Ethernet port within the first 30
		seconds after reboot/power cycle, the Opmode will
		default to “OFF.”
Default Opmode	Determines the Opmode (“ON”	set defaultopmode <on or off>
	or “OFF”) of the radio after	Example:
	reboot/power cycle. When this
	parameter is set to “ON,” the	#>set defaultopmode on
	radio will progress into
	Opmode “ON” automatically
	after a reboot/power cycle.
Opmode Start	Determines the amount of time	set defaultopmode on [<time (sec)>]
	the radio will remain in	Example:
	Opmode “OFF” after
	reboot/power cycle before	#>set defaultopmode on 60
	progressing to the default
	Opmode.
IP	IP, Subnet, and Gateway	ipconfig [<new ip> <new subnet mask> <new
Subnet	address of the radio.	gateway>]
Gateway		Example:
		#>ipconfig 10.1.1.2 255.0.0.0 10.1.1.1
TFTPD Status	TFTPD status (on or off).	tftpd [<onoff>]
	TFTPD should be turned on to	Example:
	import a file into the radio	#>tftpd on
	(such as new firmware).
	Default is off. TFTPD will
	revert to Off after rebooting.

Trango Broadband Wireless — User Manual M900S Rev C Page 21