JVC VN-V686WPU setup guide Enter the Password, Change the IP address, Launching Viewer

ITSettings

VN-V686WPU

VN-V686U

1 ConnecttotheCamera

Enter http://192.168.0.2/

Click [Go]

2 EnterthePassword

3 TopPage

Click on [Network], followed by [Basic] on the next submenu.

4 ChangetheIPaddress

Click on the menu [Network] – [Basic] to show setting page.

Frame Size

Choose the desired frame size.

JPEG Settings

Choose the compression rate from VFS1 – VFS7, or select AFS and specify the Jpeg average file size in KByte.

Approximate file size for each compression rates are as follows.

MPEG-4 Settings

Specify the desired MPEG-4 bitrate.

Change CBR/VBR, FPS, I Frame Interval and Priority when necessary.

6 LaunchingViewer

QUICK SETUP GUIDE

User name: admin

Password: vn-v686 (by default)

Basic Trouble Shooting

When some ERROR happens…

Solution 1 If DHCP server exists on the network, IP address other than 192.168.0.2 may be assigned to the camera. Ask currently assigned IP address for the network administrator or try to connect again in peer-to-peer environment.

Solution 2 With no DHCP Server, the IP address of the camera should be 192.168.0.2 by default. Change also the PC IP address so that the camera and PC are on the logically same subnet.

Solution 3 Change the IE settings not to use the proxy server for the camera IP address. Also set http://192.168.0.2/ as an IE trusted site and change the IE setting to allow Active Scripting.

Solution 4 If you have already setup another camera which was originally the same IP address with the camera this time, PC may still recognize that the corresponding MAC address to this IP is the previous one. Launch the command prompt and type “arp –a” to confirm all IP and corresponding MAC address entries. To delete all entry, type “arp –d”.

Note Ping command could be a good solution in any situation.

After selecting [DHCP Disable], enter the specified value in each fields.

Press OK and wait for 1 minute while rebooting.

Change also IP address of the PC to re-connect the camera.

5 Encodingsettings

Click on the menu [Image] – [Encoding] to show setting page.

Frame Size

JPEG Settings

MPEG-4 Settings

[Note for MPEG-4 Viewing]

Download the “ffdshow” from the Internet and install before viewing MPEG-4 image with the built-in MPEG-4 viewer.

The “ffdshow” is a open source CODEC and found at various Internet sites like http://www.free-codecs.com/FFDShow_download.htm

(as of may.2008)

7 Finish

According to your system operation policy, set the necessary settings like

•Preset Position

•Alarm

•Privacy Mask and so on.