JVC GR-AX96 manual Transmitted beam effective area, Rec Time Indicator

Transmitted beam effective area

15° 5m(16.4ft)

30
°
15°	30	°	Remote sensor

When using the remote control, be sure to point it at the remote sensor. The above illustration shows the approximate transmitted beam effective area for indoor use.

The transmitted beam may not be effective or may cause incorrect operation outdoors or when the remote sensor is directly exposed to sunlight or powerful lighting.

Interval Timer Indicator

		Viewfinder
1min	INDEX		Index Code
1/2s			Marking

Rec Time Indicator

START/STOP

VISS

INT. TIME

REC TIME

RM-V700U (optional)

	41
FEATURE:	Self-Timer, Animation and Time-Lapse
PURPOSE:	The remote control lets you set/release
	Interval Timer and Rec Time functions as
	well as the Menu screen.
OPERATION:	Self-Timer
	1) Set
	Instead of performing steps 1 through
	3 on pg. 30 (“Self-Timer”), press INT.
	TIME on the remote control. Each
	time INT. TIME is pressed, the Interval
	Timer indicator appears, changing in
	the following order: 15s, 30s, 1min,
	5min and No indication (off).
	2) Release
	Instead of setting “Interval Timer” to
	“OFF” in the Menu, press INT. TIME
	on the remote control until the
	Interval Timer indicator disappears.
	Animation
	1) Set
	Instead of performing steps 1 and 2
	on pg. 31 (“Animation”), press REC
	TIME on the remote control. Each
	time REC TIME is pressed, the Rec
	Time indicator appears, changing in
	the following order: 1/4s, 1/2s, 1s, 5s
	and No indication (off).
	2) Release
	Instead of using the Menu in step 5 on
	pg. 31, press REC TIME on the remote
	control until the Rec Time indicator
	disappears.
	Time-Lapse
	1) Set
	Instead of performing steps 1 through
	3 on pg. 31 (“Time-Lapse”), press INT.
	TIME and REC TIME on the remote
	control. Each time INT. TIME is
	pressed, the Interval Timer indicator
	appears, changing in the following
	order: 15s, 30s, 1min, 5min and No
	indication (off). Each time REC TIME
	is pressed, the Rec Time indicator
	appears, changing in the following
	order: 1/4s, 1/2s, 1s, 5s and No
	indication (off).
	2) Release
	Instead of using the Menu in step 5 on
	pg. 31, press INT. TIME and REC
	TIME on the remote control until the
	indicators disappear.
NOTE:	Also refer to pgs. 30 and 31.
FEATURE:	Index Code Marking
PURPOSE:	To give you automatic access to any
	selected point on a recording.
OPERATION:	1) Press VISS once to place the index
	code. “INDEX” blinks in the
	viewfinder during marking.
NOTE:	If VISS is pressed during Record–
	Standby mode, the mark is placed where
	RECORDING START/STOP is pressed.