TROUBLESHOOTING | 45 | ||
SYMPTOM |
| POSSIBLE CAUSE(S) |
|
POWER |
|
|
|
No power is supplied. |
| ● The battery pack has not been attached correctly | |
|
| (☞ pg. 8). | |
|
| ● The battery pack is not charged (☞ pg. 8). | |
|
| ● The power supply has not been correctly connected | |
|
| (☞ pg. 9). | |
The power suddenly goes off and doesn’t come back on by itself.
●The battery pack has completely discharged.
●Remove the cassette and disconnect the power source, then after a few minutes, try turning the power back on. If it still doesn’t come on, consult your nearest JVC dealer.
RECORDING
Recording cannot be performed. | ● The recording tape’s Erase Protection tab is missing. |
| Cover the hole with adhesive tape. (Some tapes have |
| sliding tabs. In this case, check the position of the tab.) |
Recording does not start. | ● The camcorder Power switch has not been set to |
| “CAMERA” (☞ pg. 14). |
|
|
PLAYBACK
The tape is running, but there’s no playback picture.
●The TV has not been set to its VIDEO mode or channel.
●If A/V connection is used, the TV’s VIDEO/TV switch has not been set to VIDEO.
●The RF unit has not been set to the correct channel.
Noise bars appear in the playback picture.
●Manual Tracking has not been performed (☞ pg. 35).
Playback picture is blurred or | ● The video heads are dirty or worn out. Consult your |
interrupted. | nearest JVC dealer for head cleaning or replacement. |
The counter indication is blurred | ● This is normal. |
during Still playback. |
|
|
|
TAPE TRANSPORT |
|
The tape stops during | ● The Counter Memory Function has been activated |
rewind. | (☞ pg. 35). |
Rewinding or | ● The tape is already fully wound on one reel or the other. |
be performed. |
|
|
|