JVC LYT0002-0L5A, GR-AXM88UM Begin Automatic Editing, END Automatic Editing, Edited Tape VCR Stop

							EN 41
ORIGINAL TAPE (camcorder)						AUTOMATIC EDITING TO VCR
	1		3	2			ENGAGE VCR’S RECORD–PAUSE
		IN	OUT IN OUT	IN	OUT		MODE
							Point the remote control toward the VCR’s infrared
						1 sensor and press VCR REC STBY, or manually
							engage the VCR’s Record-Pause mode.

EDITED TAPE (VCR)

STOP

BEGIN AUTOMATIC EDITING

2 Press EDIT on the camcorder, and the previously selected scenes are copied to the VCR in the specified order.

While editing, the R.A. Edit counter of the scene which is beging copied is shown with a blinking highlight.

END AUTOMATIC EDITING

3 When all selected scenes have been copied, the camcorder and VCR enter the still or pause mode. Press STOP on both units. To make the R.A. Edit counter display disappear, press R.A.EDIT.

•When finished editing, be sure to disconnect the editing cable and the audio/video cable.

EDIT

R.A. EDIT

NOTES:

●If you performed step 1 C on page 39 (“MAKE CONNECTIONS”), keep the remote control pointed at the VCR during editing.

●The on-screen display only appears while the camcorder searches for each scene.

●There may be noise at in- or out-points on the edited tape with certain VCRs.