JVC GR-DVF25 manual Rear of the LCD monitor is hot, Images on the LCD monitor are jittery

EN61

SYMPTOM

28.The rear of the LCD monitor is hot.

29.The indicators and the image colour on the LCD monitor are not clear.

30.Images on the LCD monitor are jittery.

31.The LCD monitor, the viewfinder and the lens have become dirty (ex. fingerprints).

32.The LCD monitor or viewfinder indications blink.

33.Coloured bright spots appear all over the LCD monitor or the viewfinder.

34.The LCD monitor indications are distorted.

35.An unusual mark appears.

36.An error indication (E01 — E06) appears.

POSSIBLE CAUSES	CORRECTIVE ACTION
28. •The light used to illuminate	28. • Close the LCD monitor to
the LCD monitor causes it to	turn it off or set the Power
become hot.	Switch to “POWER OFF”,
	and let the unit cool down.
29. •This may occur when the	29.
surface or the edge of the	————
LCD monitor is pressed.
30. •The speaker volume is too	30. • Turn the speaker volume
great.	down (☞ pg. 38).
31.	31. • Wipe them gently with soft
————	cloth. Wiping strongly can
	cause damage.
32. •Certain Fade/Wipe effects,	32. • Re-read the sections
certain modes of Programme	covering Fade/Wipe effects,
AE with special effects,	Programme AE with special
Picture Stabilizer and other	effects and Picture Stabilizer
functions that cannot be used	(☞ pg. 18, 27, 28, 30, 31).
together are selected at the
same time.
33. •The LCD monitor or the	33.
viewfinder is made with high-
precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD	————
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due to
any defect of the unit.
(Effective dots: more than
99.99 %)
34. •During playback of the	34.
unrecorded portion, High-
speed Search and still	————
playback, LCD monitor
indications appear distorted.
This is not a defect.
35.	35. • Check the section of the
————	manual that explains LCD
	monitor/viewfinder
	indications (☞ pg. 66, 67).
36. •A malfunction of some kind	36. • Remove the power supply
has occurred. In this case the	(battery pack, etc.), clock
camcorder’s functions	battery and wait a few
become unusable.	minutes for the indication to
	clear. When it does, you can
	resume using the camcorder.
	If the indication remains
	even though you repeat the
	above two or three times,
	please consult your nearest
	JVC dealer.

CONTINUED ON NEXT PAGE