JVC LYT0278-001A, GR-DVF7 manual Stop Recording, Press Display Button, Indicaitons reappear

Page 15

Tape remaining time indicator

25 min min

(Now calculating)

90min

89min

3min

2min

(Blinking)

1min

(Blinking)

0min

(Blinking)

Recording Start/Stop Button

DISPLAY

EN15

4

 

STOP RECORDING

 

 

 

Press the Recording Start/Stop Button again to stop

 

 

 

recording.

 

 

 

 

 

 

 

 

•The camcorder re-enters the Record-Standby mode.

 

NOTES:

 

When the Power Switch is set to “CAMERA” and the

 

LCD monitor is opened at an angle of 60 degrees or

 

more, the LCD monitor switches on and the viewfinder

 

switches off automatically to save power.

 

The cassette holder cannot be opened unless a power

 

supply is attached.

 

There may be a delay after you open the cassette cover

 

until the holder opens. Do not use force.

 

The tape remaining time is only displayed in the

 

viewfinder as shown.

 

The remaining time indicated in the viewfinder is

 

approximate.

 

The time required to calculate the remaining tape

 

length, and the accuracy of the calculation, may vary

 

 

according to the type of tape used.

 

“TAPE END” appears when the tape reaches its end, and

RECORDING

the power goes off automatically if left in this condition

 

for 5 minutes. “TAPE END” also appears when a cassette

 

whose tape is already at its end is loaded.

 

If the Record-Standby mode continues for 5 minutes, the

 

camcorder’s power shuts off automatically. Set the

 

Power Switch to “POWER OFF”, and then back to

 

“CAMERA” to turn the camcorder on again.

 

When a blank portion is left between recorded scenes

 

on the tape, the time code is interrupted and errors may

 

occur when editing the tape. Continue recording from

 

where you stop so that there are no gaps by following

 

“Recording from the middle of a tape” (pg. 20).

 

The LENS COVER warning blinks for about 5 seconds

 

when the camcorder is turned on with the cover closed.

 

While shooting, sound is not heard from the speaker.

 

LCD Monitor/Viewfinder Indications

 

You can make the LCD monitor/Viewfinder indications

 

appear/disappear.

 

 

 

 

 

 

1

 

PRESS DISPLAY BUTTON

 

 

When you do not want the indications to appear,

 

 

 

press DISPLAY for longer than approximately 1

 

 

 

second. Certain indications disappear.

 

 

 

Press again for longer than approx. 1 second to make

 

 

 

the indicaitons reappear.

 

NOTE:

 

It is impossible to make the tape running indicator “ 444

 

and warnings etc. disappear from the LCD monitor or the

 

viewfinder. For the indications that can be removed,

 

pg. 66 and 67.

 

Image 15
Contents GR-DVF7 It is recommended that you Dear CustomerAbout Batteries About DV Contents Power Charging the Battery PackUsing the Battery Pack Choose which one means charged and which means discharged Using AC PowerUsing a CAR Battery Charge MarkerRE-INSERT Holder Clock Lithium Battery Insertion/RemovalInsert Battery in Holder Remove Battery Holder Pull out the battery holderAccess Recording Menu Date/Time SettingsSelect Operation Mode Access DATE/TIME MenuINSERT/REMOVE Tape ContOpen LCD Monitor Open Cassette CoverSet depending on your preference Recording Mode SettingSET Recording Mode First move the highlight bar to REC Mode byViewfinder Adjustment Grip AdjustmentAttach Strap Adjust LengthShoulder Strap Attachment Tripod MountingLoad a Cassette Power Switch PositionFull Auto mode PRO. modeIndicaitons reappear Stop RecordingPress Display Button RecordingRecording Basic Recording Shooting While Watching The LCD MonitorBefore the following steps, perform pg Journalistic Shooting Interface ShootingBrightness Control Zoom Out Feature Picture StabilizerBasic Recording ZoomTo brighten the scene when natural lighting is too dim Feature Video LightProper recording When blank portion is recorded on a tapeSET Function Parameters Recording Advanced Features EN21Displaying The Date And Time During Recording Select FunctionSnapshot Recording Advanced FeaturesSnapshot Mode Selection SnapshotEN23 Motor Drive ModeSelect Function Parameters in DATE/TIME Menu or System Menu Using Menu For Detailed AdjustmentMake Setting END SettingRecording Menu Explanations Factory-presetSystem Menu Explanations Date/Time Menu ExplanationsB K , , B W Fade/Wipe EffectsEffect Selection FADE/WIPE SelectionIf you select Picture Wipe/Dissolve during recording Store Scene in Memory Engage the Record-Standby modePicture Wipe or Dissolve Selection P, P, P, P , P, P and P Before the following steps, perform steps 1 through 3 on pgMenu Fader And Wipe MenuProgramme AE With Special Effects Recording Advanced FeaturesSelect Mode Disable ModeMonotone ShutterTwilight SepiaFocusing Auto FocusPatterns that are regularly repeated END Adjustment of Focus Access Manual Mode Item MenuAccess Manual Focus Adjust FocusTo darken the image Access Exposure ControlIf you want to reset the exposure, repeat step Exposure ControlTo Return To Automatic Iris Control Iris LockCentre SUBJECT, Lock Iris IrisTo Return To Automatic White Balance White Balance AdjustmentAccessment White Balance Adjust Select Auto in . Or set the Power Switch toTo Change The Tint For Recording Enter SettingManual White Balance Operation Exit Manual White Balance AD- JustmentSpeaker Volume Control Playback Basic PlaybackRewind or Fast-forward the tape Feature Playback Zoom Feature Still PlaybackFeature Shuttle Search Feature Slow-Motion PlaybackPlayback Menu EN PlaybackPlayback Sound Displaying The Time Code During PlaybackRecording sound Display Output sound Use the provided Audio/Video A/V cable When connecting the cables, open this coverEN Playback Connections Use the provided Audio/Video A/V cable and S-Video cableConnectinput VCR Output to TV Supply Power Connectvcr Camcorder to TV orTurn on the camcorder, the VCR and the TV Tape Dubbing Installing The Battery Pull OUT Battery HolderRemote control uses one lithium battery CR2025 Buttons FunctionsTo stop Slow-Motion Playback in progess, press Play To allow slow-speed search in either directionDown Playback ZoomActivate Zoom END ZoomSelect Playback Effect Accessmenu Playback Effect SelectPlayback Special Effects Start PlaybackOperate VCR Random Assemble Editing R.A.EditSET REMOTE/VCR Code SET Remote to Operate VCRSelect Scenes Make ConnectionsPress FADE/WIPE Select ScenesUSE FADE/WIPE on Scene Transition if Necessary USE Programme AE with Special Effects if NecessaryAutomatic Editing to VCR Prepare Source TapeStop Editing Choose a Scene For More Accurate EditingDiagnosing VCR’S Against Camcorder Timing Prepare for R.A. EditClose Menu Adjustment of VCR’S Against Camcorder TimingAccess Playback Menu Input Correction DataStop Dubbing Audio DubbingBegin Dubbing Pause During DubbingNew track is output on both L and R channels in stereo Original and new tracks are combined and output in stereoCorrective Action Delay of a fraction of a Snapshot mode cannot be used Digital Zoom does not workShutter mode of Programme When using Picture WipeDisappear Than 1 second to make Places subject to low Adjust the brightnessCamcorder When the LCD monitor’s Fluorescent light reaches Picture Wipe function does not workLCD monitor or viewfinder indications blink Battery pack, etc., clockRear of the LCD monitor is hot Images on the LCD monitor are jitteryCharging is difficult in places Power lamp blinks There are disturbances in audioTemperature To protect the battery, it is Recommended to charge itAfter Use Clean ExteriorClean LCD Monitor Clean Lens64EN External Stereo Microphone Input Connector MIC Video Light Switch$ Power Switch Battery Release Switch Connectors to r are located beneath444 IndicationsLCD Monitor/Viewfinder Indications During Recording FunctionLCD Monitor/Viewfinder Indications During Playback Indications FunctionFunction Exposure Control ...................................... pg Pg , 7Pg , 42 Date/Time DisplayDuring use For safety, do notAvoid using the unit To avoid hazardTo prevent damage to the LCD monitor, do not To prolong service lifeDo not leave the unit To protect the unit, do notGeneral AC Power Adapter/Charger AA-V15EGConnectors CamcorderGR-DVF7

GR-DVF7, LYT0278-001A specifications

The JVC LYT0278-001A, also known as the GR-DVF7, is a compact yet powerful digital camcorder renowned for its innovative features and user-friendly design. This camcorder is designed to cater to both amateur and semi-professional videographers, delivering high-quality video capture along with a host of functionality.

One of the standout features of the GR-DVF7 is its 1/4-inch progressive scan CCD sensor. This technology allows for improved light sensitivity, enabling users to capture clear and vibrant footage even in low-light conditions. This makes it an ideal choice for recording events such as weddings or indoor activities, where lighting can often pose a challenge. Additionally, the camcorder supports a maximum resolution of 800x600 pixels, producing crisp images with fine detail.

The GR-DVF7 offers a 10x optical zoom, allowing users to get close to the action without sacrificing image quality. This is complemented by a digital zoom feature, which further enhances the zoom capabilities, albeit with some trade-off in clarity at higher magnifications. The combination of optical and digital zoom makes this camcorder versatile for various filming situations, from capturing distant landscapes to intimate moments.

In terms of audio quality, the JVC GR-DVF7 is equipped with a built-in stereo microphone, ensuring that sound capture is as clear and balanced as the visuals. Furthermore, this camcorder features an easy-to-use interface with a large LCD display, which swivels for flexibility during shooting and playback. The interface is intuitive, allowing users to adjust settings quickly and easily, ensuring that they can focus on capturing the moment.

The device is designed for portability, with a lightweight build that makes it comfortable to hold during extended periods of shooting. It also supports various recording formats, providing flexibility in how footage is stored and shared. The battery life is commendable, allowing users to film for longer without needing to recharge, which is crucial for events that last several hours.

Overall, the JVC LYT0278-001A, GR-DVF7 stands out in the digital camcorder market for its balance of advanced technology, user-centric design, and high-quality performance. Whether capturing memories or producing content, this camcorder remains a reliable choice for videographers looking for an efficient and effective filming solution.