JVC GR-DVL145 specifications 48 EN, For replacement

Page 48

48 EN

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the beginning.

1

SYMPTOM

POSSIBLE CAUSES

CORRECTIVE ACTION

2No power is supplied.

• The power is not connected

• Connect the AC Adapter securely

 

 

properly.

( pg. 9).

 

 

• The battery is dead.

• Replace the dead battery with a

 

 

 

fully charged one ( pg. 8, 9).

 

 

 

 

 

“SET DATE/TIME!”

• The date/time is not set.

• Set the date/time ( pg. 11).

3appears.

• The built-in clock battery has run

• Consult your nearest JVC dealer

 

 

out and the previously set date/time

for replacement.

 

 

has been erased.

 

 

 

 

 

 

Recording cannot be

• The tape’s erase protection tab is

• Set the tape’s erase protection tab

4performed.

set to “SAVE”.

to “REC” ( pg. 12).

 

 

• The Power Switch is set to “PLAY”

• Set the Power Switch to “ ” or

 

 

or “OFF”.

“ ” ( pg. 16).

 

 

• “TAPE END” appears.

• Replace with new cassette

 

 

• The cassette holder cover is open.

( pg. 12).

 

 

 

• Close the cassette holder cover.

 

 

 

5There is no picture.

• The camcorder is not getting

• Turn the camcorder’s power off

 

 

power, or some other malfunction

and on again ( pg. 16).

 

 

exists.

 

 

 

 

 

 

The focus does not adjust

• Focus is set to the Manual mode.

• Set Focus to the Auto mode

6automatically.

• The recording was done in a dark

( pg. 29).

 

 

place, or the contrast was low.

• Clean the lens and check the focus

 

 

• The lens is dirty or covered with

again ( pg. 53).

 

 

condensation.

 

 

 

 

 

 

The cassette will not load

• The cassette is in the wrong

• Set it in the right position

7properly.

position.

( pg. 12).

 

 

• The battery’s charge is low.

• Install a fully charged battery

 

 

 

( pg. 8, 9).

 

 

 

 

 

Snapshot mode cannot be

• The Squeeze mode is selected.

• Disengage the Squeeze mode

 

used.

 

( pg. 34).

 

 

 

 

Page 47 Page 49
Image 48
Page 47 Page 49
Contents GR-DVL145 Dear Customer It is recommended that youBlue to N Neutral or Black Brown to L Live or Red Some DO’S and DON’TS on the Safe USE of Equipment Before recording an important scene How To Attach The Lens Cap Power CordAttachment Shoulder Strap Cable AdapterHow To Attach The Core Filter MENU/BRIGHT Wheel Lock Button Power Switch Sub MenuStopper Wind once Getting Started Power To Detach The Battery PackPress BAT. Release and pull out the battery Pack Charging timeAbout Batteries Approximate recording timeBenefits Of Lithium-Ion Batteries Grip Adjustment Viewfinder Adjustment10 EN Shoulder Strap AttachmentDate/Time Settings Approximate recording time Tape Recording mode 12 ENLoading/Unloading a Cassette Recording Mode Setting Set the tape recording mode depending on your preferenceSP mode Audio Dubbing  pg and Insert Editing14 EN Shooting while using the viewfinder Close the LCD monitor To Adjust The Brightness Of The DisplayBasic Recording To Stop RecordingOperation Mode Power Switch Position16 EN Slide the Power Zoom Lever towards T ZoomZoom Out Zoom in T TelephotoWhen a blank portion is recorded on a tape 18 ENTime Code Proper recordingTo Control The Speaker Volume Normal Playback20 EN ConnectionsCamcorder TV or VCRIf using a VCR . . . go to step If not . . . go to step To cancel Blank Search midway 22 ENBlank Search Press Blank SearchAdvanced Features To Deactivate The Selected Mode 24 ENNight-Scope To Deactivate Night-ScopeSports Variable Shutter Speed 1/250 1/4000 Makes evening scenes look more naturalGives recorded scenes a strobe effect Your recording looks like a series of consecutive snapshots26 EN Fade/Wipe EffectsTo Deactivate The Selected Effect Fader And Wipe Menu Menu Effect28 EN SnapshotWhile focusing on a nearer subject To obtain correct focusFocus detection zone Subject30 EN Exposure ControlIris Lock White Balance Adjustment Manual White Balance OperationTo Return To Automatic White Balance 32 EN For Recording MenuSee pg If you have selected CAMERA, MANUAL, System or DisplayFactory-preset Menu Screen Explanations16X 40XScreen ratio becomes Appears. When using this mode, refer Normal screen ratioScreen and the image appears like a letterboxed 169 movie Recording. Also to activate the shutter sound effect  pgWhen the Menu Screen is closed after Demo Mode is turned on After the Power Switch is set to orDoes not reset all settings to the factory-preset Resets all settings to the factory-preset36 EN For Playback MenuPlayback Sound DisplayPower Switch Connector cover To AV Optional Plug provided To AUDIO, Video Connectors Cvbs38 EN Dubbing To a VCRTo DV OUT Core filter Lock ButtonDV cable Optional40 EN Lock holeKnob Remote sensor This function is unavailable with this camcorder 42 EN Remote sensor RM-V700U optional Zoom ButtonsNormal playback Press T Set 12BIT Mode to Sound 2 or MIX Menu Screen  pg Audio DubbingTo hear the dubbed sound during playback Lock Button Power Switch Display 44 ENInsert Editing System Connections 46 EN Charging times are for a fully discharged battery pack Battery packSet the Power Switch to PLAY, or Detach the battery from the camcorderFor replacement 48 ENColour of Snapshot Find a white subject and compose50 EN Menu Screen Menu Screen  pgImage colour on the LCD Edge of the LCD monitor is Modes of Programme AE withRmonitor or the viewfinder 52 EN Cleaning The Camcorder OPEN/EJECT Switch BAT. Release Button Hatch Lens blowerAfter Use RemoveTo prevent damage and prolong service life 54 ENTo avoid hazards During useTo prolong service life For safety, do notAvoid using the unit To prevent damage to the LCD monitor, do notDirty heads can cause the following problems 56 ENAbout moisture condensation Serious malfunctioningPower supply Power consumptionDimensions W x H x D Weight58 EN 5 6Audio/Video Output Connector Video Output ConnectorDigital Video Connector LCD Monitor Bright Brightness60 EN LCD Monitor/Viewfinder Indications During RecordingDisplays the sound mode LCD Monitor/Viewfinder Indications During Playback116 21 Bright Displays the brightness62 EN Index IndicationsBacklight Compensation  pg , 9Channels Left/Right Darken The LCD MonitorPg , 35 Unload a TapeWhite Balance See previous page as well
Related manuals
Manual 64 pages 31.2 Kb
Top Page Image Contents