JVC GR-DVL257  pg, Possible, Switch is set to, Appears, the memory card is corrupted

84 EN			INDEX Indications (cont.)
	Indications	Function
	INSERT ERROR!	Appears if Insert Editing is attempted on a blank portion of a tape.
			( pg. 67)
	INSERT ERROR!	● Appears if Insert Editing is attempted on a tape recorded in the LP mode.
			( pg. 67)
	<CANNOT EDIT
	ON A LP RECORDED	● Appears if INSERT (w) on the remote control is pressed when the erase
	TAPE>	protection tab is set to “SAVE”.	( pg. 67)
	<CHECK TAPE’S ERASE
	PROTECTION TAB>
	MEMORY IS FULL	Appears when the memory card’s memory is full and shooting is not
		possible.

●Appears if dubbing of copyguarded signals is attempted while this camcorder is being used as a recorder.

●Appears in the following cases when dubbing from a tape to a memory card:

–when no memory card is loaded.

–when the memory card's memory is full.

–when the memory card is not formatted.

COPYING FAILED	– when a copy-protected SD Memory Card is loaded.			( pg. 56)
	● Appears in the following cases when dubbing still images stored in the
	memory card to a tape:
	– when condensation occurs.
	– when no tape is loaded.
	– when the erase protection tab is set to “SAVE”.
	– when a tape in another format is loaded.			( pg. 55)
	– when the tape ends.
	Appears if a memory card is not loaded when SNAPSHOT is pressed while
MEMORY CARD!	the Power Switch is set to “ ” or “ ” and the VIDEO/DSC switch is set
	to “	”.		( pg. 26)
PLEASE	Appears when there is a problem with a memory card and its memory is
	corrupt, or it has not been initialilsed. Initialilse the memory card.
FORMAT
				( pg. 36)
NO IMAGES STORED	Appears if there is no images stored in the memory card when the Power
	Switch is set to “		” and the VIDEO/DSC Switch is set to “	”.
	Appears when the camcorder takes more than 60 seconds to recognize the
CARD ERROR!	loaded memory card. Remove the memory card once and insert it again.
	Repeat these procedures until no indication appears. If the indication still
	appears, the memory card is corrupted.
CHECK CARD'S WRITE	Appears when you attempt to shoot digital still images while a copy-
PROTECTION SWITCH	protected SD Memory Card is loaded.
E01 — E06	The error indications (E01 — E06) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off
UNIT IN SAFEGUARD
	automatically. Remove the power supply (battery, etc.) and wait a few
MODE REMOVE AND
	minutes for the indication to clear. When it does, you can resume using the
REATTACH BATTERY
	camcorder. If the indication remains, consult your nearest JVC dealer.